Electronics Forum | Sat Oct 03 15:51:06 EDT 2015 | amrsalama
I have the same problem and while using logicomm it gives an error message (FC107F24) !!! how can I read this error to address the problem ???
Electronics Forum | Fri Aug 07 18:09:55 EDT 2015 | bnorton
The power distribution board has 10 green LEDs on. By the time of the error SysFail is still on. Logicomm connected to the Force board COMM2 shows a stream of messages saying "Lantern system not active. Heart Beat = 0"
Electronics Forum | Wed Aug 12 14:06:25 EDT 2015 | bnorton
We tried restoring the Machine Configuration, Mapping, and Calibration data from after the calibration done last year. The error was still present after the restore and restart.
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON
Electronics Forum | Wed Aug 12 12:02:41 EDT 2015 | edwaterfall01
I think the heart beat message comes up if the vision had not initialized. You have changed that already stop I think it is something else. Have you some money a Restore of the Machine Configuration and Mapping and Calibration Data?
Electronics Forum | Wed Aug 12 17:41:15 EDT 2015 | edwaterfall01
Sorry for all the typos in the last message. As the machine was powered OFF for two weeks I would have expected a battery problem. Can you capture a Logicimm file and see what the file says before the heart beat messages?
Electronics Forum | Tue Oct 06 20:18:27 EDT 2015 | edwaterfall01
With the address of FC107F24 I would look at the Slot 11 UIMC board. Try swapping with another Radisys Board. Check jumpers, changing one jumper only on each board.
Electronics Forum | Fri Oct 09 04:51:49 EDT 2015 | amrsalama
Thanks NRS, yes UIMC by mistake was in incorrect slot (11) once we moved it to slot 12 it works, thanks again.
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
.gif)
