Electronics Forum | Fri Sep 24 11:38:32 EDT 1999 | danielm
I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than space
Electronics Forum | Fri Sep 24 23:33:30 EDT 1999 | Earl Moon
| I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than spac
Electronics Forum | Sun Sep 26 14:09:24 EDT 1999 | jgodfrey
| | I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than sp
Electronics Forum | Mon Sep 27 04:08:25 EDT 1999 | Earl Moon
| | | I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than
Electronics Forum | Wed Nov 29 23:17:37 EST 2006 | raychamp007
Dear Friend, SMD E-cap wasn't a Flat ribbon, L or gull wing. Pls. look at SOIC & QFP for Flat ribbon, L or gull wing. So far IPC had confirmed dont have any criteria set specific for SMD E-cap.
Electronics Forum | Tue Apr 10 20:32:57 EDT 2007 | raychamp007
Dear Friend, Any one can tell is there any different between Flat Ribbon and Gull Wing Component? Any one pls give an example or provide a picture of flat ribbon component. Thanks.
Electronics Forum | Thu Apr 12 15:53:59 EDT 2007 | realchunks
Steve is right. There is a difference between flat ribbon "devices" and flat ribbon "cable". IPC standards are the same for flat ribbon as gull wing. Here's a pic for example: http://www.topline.tv/FLATPACK.html
Electronics Forum | Thu Dec 19 03:02:48 EST 2019 | sssamw
I cannot see it's a gull wing lead, but also there's no solder under the lead except the side surface.
Electronics Forum | Wed Aug 15 16:09:59 EDT 2001 | monkey
Good fillet at the heel is most critical. Check out IPC standards for acceptable solder joints.
