Electronics Forum | Thu Jun 25 18:28:23 EDT 1998 | Earl Moon
| Looking for articles/data comparing the quality/reliability of mass | reflowed SMT solderjoints versus hand soldered SMT solderjoints. As solder joint quality most often is subjective - that is visually compared with graphic examples, IPC is the B
Electronics Forum | Sat Jun 05 13:38:22 EDT 2021 | ppcbs
For Linear Tech LGA's we solder bump the LGA using a .30mm solder ball then reflow with a tacky flux. This will provide a void free solder joint and adds a little height to the solder joint in case you use a flux that you want to clean from under th
Electronics Forum | Mon Oct 05 14:38:03 EDT 2015 | deanm
We are planning on using a chip that is available in LGA or Sn/Pb balled BGA. The package dimensions are the same. Pitch = 1.27mm. We are using a Sn/Pb soldering process and no clean paste (wash afterward) for high reliability Class 3 assemblies. Fai
Electronics Forum | Thu Feb 12 21:06:20 EST 2004 | davef
"LGA" [land grid array] is a pretty broad topic. Search the fine SMTnet Archives for background on: * BGA * uBGA * Flip chip * etc Consider: * Area Array Packaging Handbook: Manufacturing and Assembly; Ken Gilleo; McGraw-Hill Professional; 1st edit
Electronics Forum | Mon Mar 08 16:23:24 EST 1999 | Dave F
| Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? | | Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just
Electronics Forum | Mon Jun 05 10:42:28 EDT 2017 | philc
I guess it all depends on volume. If you are talking thousands of PCB's, then automation is best, if possible. Otherwise, hand-soldering them post-production is the obvious solution. How about bill-boarding them? That way, they would fit on the land
Electronics Forum | Fri May 07 02:37:31 EDT 1999 | Bob Willis
| Mornin! | | We just had vendor in here pitching a "low-temperature rework system" which was intriguing, but too expensive. He did get me to thinking though, beyond heating ceramic caps before hand-soldering them, it seems like it would be ad
Electronics Forum | Mon Mar 25 21:50:10 EST 2002 | davef
Some of this was copped from Fred. There are numerous package types that now fall under the rubric of land grid array [LGA]. Land grid devices [ie, Bumped Chip Carrier� [BCC], LGA, Quad Flat-pack No-lead [QFN], MicroLeadFrame�, etc] are essentially
Electronics Forum | Tue Dec 19 21:23:39 EST 2006 | davef
We'd suggest using your connector supplier recommendations. Some use: * Pad Plating: 20-30 uin Au over 50 uin Ni (You might get away with less gold) * In-Pad Vias: less than half the diameter of the button (for contact-only configurations) * PCB/C
Electronics Forum | Thu Aug 11 12:45:42 EDT 2016 | anhsang38
Dear All I have a question for the reflow machine. I'm using Vitronics(Mr933+)reflow. The peak temperature of the (Chip, LED, SOT) component higher than (QFP,LGA) about 4 degree when i measured proflie. All of them on the same board . I don't know w
winsouce.jpg)