Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Fri Feb 15 13:45:18 EST 2013 | cowens
We have a MPM UP2000. We are getting a hardware limit error when we turn the machine on and try to reset. The F14 fuse blows every time we replace it. The downstop is the first axis that it tries to go through but we get this error. Any help would be
Electronics Forum | Fri Sep 08 10:23:38 EDT 2006 | slthomas
By profile (profile has not been changed) are you referring to the oven zone settings or the actual charted profile of a trip through the oven as recorded by a thermal profiler? Some ovens will continue to function without warning as long as temps
Electronics Forum | Sat Aug 18 10:35:41 EDT 2018 | mgerrior
Hey Phil, i'm just curious what your rework processes are for your hardware after conformal coating is applied (if any). I'm interested in conformal coating as our hardware can be exposed to moisture rich environments at customer sites but to my kno
Electronics Forum | Mon Jul 20 15:53:10 EDT 2020 | robl
Tape test to check adhesion and multiple point thickness test - each board has 5 points per side documented for thickness testing & we measure pre & post coating thickness with an electronic meter. Also temp & humidty are also logged, and alarms go o
Electronics Forum | Thu Oct 21 11:15:00 EDT 2010 | jorge_quijano
Do you know in which axis the problem occurs? usually when "hardware limit error" shows is because one of the axis touches the sensor of the limit, this is to prevent the mechanism hit something, If you machine is used, you can check if there is a mi
Electronics Forum | Mon Mar 30 15:16:32 EDT 2009 | Peter
Hi Tom, You're right. I do find the second locating pin hardware. Now I got them both up/down when F3 is pressed. Thanks. I don't see any pin on the hardware and no edge clamp hardware either :-( , do you know any way that I can bypass these hardware