Electronics Forum | Wed Jun 11 08:53:53 EDT 2014 | fredcalkins
That would be easy to check. Degaus the whole nozzle not just the tip. It should take more than a week to become magnetized again. If it becomes magnetic sooner maybe degauss the head? I would also make sure your vacuum does not come on till the noz
Electronics Forum | Thu Sep 13 17:29:02 EDT 2007 | fnorradd
I am currently having a problem with uncut legs on one side of axial components from a universal dual head insertion machine. Initially it was thought that the anvil on one side was engaging slow so I stripped down and changed the seals in the botto
Electronics Forum | Mon Aug 01 18:33:21 EDT 2005 | crishan
Hi All, We are not using a Vib. bowl feeder, or stick feeder, these parts are on a reel. The pick & place machine we are using is a Panasonic brand YV100X, its a single head with 8 nozzles. What we are finding is that the component package size is
Electronics Forum | Wed Jun 15 22:27:40 EDT 2011 | pkamath2
Hello, My company recently installed a Positive Displacement Pump on a GSM Pick @ Place machine for dispensing chipbonder (loctite 3621) dots before mounting chip components. The head uses Universal stand nozzles (single port-small dot, dual port 0
Electronics Forum | Sat Sep 26 14:54:52 EDT 2015 | ercdave1
Hello, just a quick update on this issue. I disabled head 2 on beam 2 which was the second head I worked on, and left only active the head that I had work with first and ran dry cycle with. after disabling the head 2, the machine zeroed with no pr
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Sat Mar 26 02:38:07 EDT 2011 | evans1001
Had an issue with spindle 2 not coming down and picking parts up, then it was but not placing the part. The other 3 spindles were working fine. Changed the head on the machine but stil had the same issues. Anyone with any ideas. Cheers
Electronics Forum | Wed May 21 09:03:52 EDT 2008 | bing007
I have been confronted with a MPM with a rheometric pump head on and have not had much to do with these. It is giving varying results on the down line paste AOI and is not responding very much to changes in pressure, speed etc. It is a 16inch pump, w
Electronics Forum | Tue Feb 12 10:51:46 EST 2002 | stefwitt
Dave is right. There is no machine on the market which can handle a 1.5 m long "board". If you or someone else will have to tinker with a custom made machine, it will be less expensive to use a used machine ( I could be offering some used Siemens mac
.gif)
