Electronics Forum | Thu Mar 20 11:30:58 EDT 2014 | dave222
Hello Again. I little more information about the issue: when trying to zero machine head the spindles move up and down about 6 times before giving the error code. also I notice that all the LEDs on the circuit board are off. L11 - L18. and the nume
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Sat Sep 05 16:09:10 EDT 2015 | emanuel
Need assistance - I want to disconnect an unused LCS module from an Emerald machine. I disabled the tray changer and buffer conveyor in the machine's configuration but I still get an L212 error on the bottom of the screen and the machine hangs during
Electronics Forum | Mon Feb 20 13:43:54 EST 2012 | acsscott
Having a problem at power up, that our Philips Topaz X displays "DOWNLOAD IO STN.DATA NG" in red. It times out after about 5 minutes, then comes up. When we try to find the origin, it gives an error that the "Head Down sensor is OFF". If we go int
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Tue Feb 12 12:47:02 EST 2019 | slthomas
Someone with some more definitive knowledge of these machines will no doubt chime in at some point, but my thought was that the "A-table" is just a data table that stores I/O information. Thus, being "off in A-table YV100X:N2323 YV100XT:n2223" just m
Electronics Forum | Sun Oct 11 21:19:51 EDT 2009 | fulldrawmike
we have both flexjet and flexhead, we also have the new inline 7 head on some genesis dual beams we just put into operation. If you have a choice in flexjet heads take the inline 7. The flexjet 09 head is very labor intensive, stay away from them, e
Electronics Forum | Mon Sep 30 16:36:00 EDT 2013 | richardconnell
I have a Universal Instruments Corporation TAB Bonder. Oldish machine. Initial fault on machine : - "Axis Head 1 Z DAC Limit error during move absolute command" Other fault seen after we reset power, Zeroed axis etc. - Axis Head 1 - Z error not re
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
