Electronics Forum | Thu Feb 03 19:05:12 EST 2011 | thejedeye
Can someone help please, purchasing agent guessing which p/n needed, for a Samsung CP 40CV there are 3 - 30MM filter located behind vacuum head, we think its one of these p/n's. P/N J1300300-I, P/N J1300300, P/N J1301351 TiA Thanks
Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Electronics Forum | Thu Jul 30 12:55:16 EDT 2020 | fujipro
If there is no visible fault on the affected Shaft, perform maintenance on the Head. Replace Filter and exchange the Mechanicial Valves or replace the O-Rings on it.
Electronics Forum | Wed Mar 20 14:54:15 EDT 2024 | linux
Vacuum Low, Shows up on changeover when the head picks a different size nozzle, remove mesh filter, unplug the clear pipe from the top of the head, put a small amount of alcohol down the pipe and blow it out with the air gun, You should check for a h
Electronics Forum | Thu Mar 28 20:06:53 EDT 2024 | cbeneat
What type head is it? Try changing the internal filters. If it is a low number head, ie: 1-4 on an 8, 1-6 on a 12 or 1-8 on a 16. These can be accessed by pushing the head to the opposite table for removal. Chapter 11, section 11-6 page 11-6.3 in mai
Electronics Forum | Mon Aug 29 13:34:58 EDT 2016 | mhanrahan
We had this issue with our old MV 150. This was usually due to clogged/dirty or bent nozzles, or clogged dirty filters on the vacuum supply to the head.
Electronics Forum | Wed Aug 12 14:35:33 EDT 2015 | ehess
having a problem with several heads miss picking 8mm feeder parts. Had to bypass 2 of the heads because it was becoming such a hardship. Heads 3, 4 (bypassed), and 8 (bypassed). On 3 and 8, it will miss so many it errors, and when I clear the erro
Electronics Forum | Tue Apr 18 12:03:30 EDT 2023 | dskling
No. they struggle to move a little but not a full cycle. We have replaced the 3 control boards on the back door, both EMI filters, check and replaced all fuses, pulled the clinch head and swapped it with another working clinch head and that blew a c
Electronics Forum | Sun Feb 15 17:12:15 EST 2004 | brian bennett
as george says move beam back towards the centre of the machine make sure it is square although not neccesarily on the alignment arrows. make sure alignment laser is clean along with the recieving mirror on the head.also make sure the driver filters
Electronics Forum | Wed Dec 19 15:39:46 EST 2018 | emeto
Sure Dave, with the amount of daily information going though our heads I would love to see spam filters working better. I am just debating of it is not better to be user/IP related rather than headline related. There are about 10-15 of them(some US