Electronics Forum | Mon Apr 03 18:55:23 EDT 2023 | previnmoore
Im having a problem with the Juki KE2080 it's telling me that there is a head lifter error.
Electronics Forum | Tue Nov 07 10:16:20 EST 2006 | kevinp
The touch down sensor is probably the culprit, however make sure the head is not impacted with old solder paste and that the cylinders that flip the head are functional. I have had problems with one of the cylinders not functioning this caused the he
Electronics Forum | Fri Sep 20 19:06:09 EDT 2002 | mjabure
The way it works is the first index is done with the feed cylinder, and the final is done using the cam during pick. You might want to check to make sure you're getting a full, complete stroke out of your feed cylinder, also make sure the mechanism
Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
Electronics Forum | Wed Apr 03 22:07:13 EDT 2024 | compit
Not every program can clone a CF card. I did it but I need to check with what kind. You can also simply insert a new CF card into the machine, INSTALL DOS from floppy disks (same version) and then COPY the entire disk EXCEPT the system files (msdos.s
Electronics Forum | Sun Feb 01 17:28:24 EST 2009 | tpappano
The feeders on the CSM84 actually feed the tapes forward by the force of a spring. On the 8mm and 12mm feeders the spring is loaded directly by the force of the push rod on the placement head. With the larger tapes like 16mm and 24mm, a stronger sp
Electronics Forum | Thu Nov 29 15:52:53 EST 2007 | jmelson
Some other machines are a lot simpler. Here's how the Philips (mady by Yamaha) CSM84 works. Smaller tape (8 and 12 mm) feeders are all mechanical. A plunger on the head pushes a lever on the feeder at the same time the head comes down. First, the
Electronics Forum | Mon Jul 08 18:45:53 EDT 2019 | assuredtech
Would you happen to have the Jig used to check that the component itself is in spec with UIC's general specifications? 1.) Component in spec. 2.) Correct 2.5mm pusher on the feeder / dispense head. Also set the conditioner guide where the comp enter
Electronics Forum | Thu Jul 10 13:24:59 EDT 2014 | sargeredarmy01
Ok so here is where I am with everything. I pulled the cylinder and cleaned it out. Didn't find anything out of the ordinary inside. I set everything back up and tested it. Still nothing. I went into the I/O map and tracked down that input, I then
Electronics Forum | Thu Dec 26 16:51:47 EST 2002 | davef
First, an earlier poster suggested using DI water. We are NOT excited about DI water with a NC fluxer, unless DI water is the proper flux thinner. Second, as you inplied, the maintenance steps you take should vary according to the amount of time th
winsouce.jpg)