Electronics Forum | Thu Oct 02 17:00:44 EDT 2008 | davef
Is that accurate? If so, what are your aspect & area ratios? [Similar to the JerryS comment above.] * You say, � � and the average height is very high: nearly 200 pct.� => Our troop can make paste that height too. They snap the stencil-off a fast as
Electronics Forum | Thu Oct 02 01:47:57 EDT 2008 | myleb
I'm new to SMT. Now, i'm making program for SPI machine to inscpect for solder paste of SP60-MU. I think this is a very good printer but some times, my program shows only 50-60% of volume transfer; and the average height is very high: nearly 200 pct.
Electronics Forum | Thu Oct 02 12:22:26 EDT 2008 | JerryS
Hello Ok there is not much info here. What you have to mae sure of is several key factors. 1. Have you entered the correct stencil thickness. 2. Are you using the stencil gerber (not the paste layer) The paste layer is usually not adjusted for ap
Electronics Forum | Tue Jan 07 23:38:08 EST 2014 | m_imtiaz
want to know the tolerance the paste height in the solder paste printing. for example if stencil thickness is 7 mil, what will the acceptance level of paste height ( upper and lower) kindly share if any guidelines or formula for the same
Electronics Forum | Tue Dec 23 07:38:35 EST 1997 | raymond
how to determine the optimum solder paste height ?
Electronics Forum | Tue Aug 04 03:54:04 EDT 2009 | rafacadiz
I would like to perform a Solder paste height capability study. I will apreciate any info about and what equipment use to measure the height of the solder paste. I only found the attached equipment. Solder Paste Height Measurement System (SPM-300-3D
Electronics Forum | Tue Jul 13 14:48:49 EDT 2004 | Mark
I was wondering some input on what to use for measuring height on our solder paste for SMT placement. Is there a place to buy a machine or a scale in which you can use? I know in the past I have used a laser scope at another facility but where I am n
Electronics Forum | Fri Mar 06 12:38:34 EST 2009 | mgershenson
Is this a manual measurement machine? As already stated, knowing the height of the pad underneath the paste brick is critical to knowing the true height an/or volume of paste. Any decent automated inspection system will have a way to factor out the p
Electronics Forum | Thu Mar 05 20:32:17 EST 2009 | davef
Most likely, placing components will smush the higher points on the edges of your paste deposit
Electronics Forum | Tue Aug 04 06:49:12 EDT 2009 | davef
solder paste inspection SMTnet => search the fine Archives
