Electronics Forum | Mon Oct 23 19:00:30 EDT 2006 | cadcopac
Have you tried to clean the lens at the tip of the pen? Use alcohol should work like new unless it is defective. Ours was driving me nuts till the brainwave hit and has been working ever since. Good luck. John
Electronics Forum | Thu Dec 08 22:35:41 EST 2005 | fastek
Harry- That's true but we weren't hear to discuss what's the cheapest printer around. The guy wants to step up in technology without jumping into the Mercedes-Benz of printing. In my mind any MPM printer below a UP-2000 would not serve his purpose.
Electronics Forum | Fri Dec 09 16:04:15 EST 2005 | valuems
Hi Rick Your right and I a agree with you. But I think there is to many people looking at the HiE machines, when all they need is a UP2000. The only advantage of the HiE machines is that they are quicker. But they seem to have a couple of problems
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
Electronics Forum | Fri Feb 08 15:00:05 EST 2019 | mattkehoe
We are very close to having the printer up and running but have hit a snag that we hope someone has seen and can offer a work around. The machine does not have the auto stencil wiper attachment parts in it. Did not matter before the hard drive crash
Electronics Forum | Sun Dec 22 11:02:44 EST 2002 | valuems
I am breaking a cardinal rule with this reply, but here goes. I believe almost every one is missing this one. Roger has hit the nail on the head. The gentleman is useing a clam shell printer and when the stencil lifts (too fast) and at the angle o
Electronics Forum | Tue Feb 18 06:29:04 EST 2020 | leeg
We are having a few issues lately with a Data file open error on the printer and also the belts carrying on spinning when the PCB has hit the board stop even though the board stop sensor is activated that it has seen the PCB, anyone seen these issues
Electronics Forum | Thu Feb 15 12:34:11 EST 2007 | flipit
Does Ekra or MPM require stencil fiducials be filled with Black Max or some other black epoxy? We still require our stencil supplier to do this. I did not have to do this on any Dek solder printers since 1997. Can the MPM UP2000 HiE fiducial light
Electronics Forum | Wed Aug 07 05:31:24 EDT 2019 | spoiltforchoice
Yes, the servicing certainly seem to be quite high and that seems to be a bit of a pattern for Blakell Europlacer in gerneral. In the past they have indicated it was an area they might be prepared to be a bit flexible on by factoring in your usage, t
