Electronics Forum | Mon Sep 14 08:07:24 EDT 2009 | davef
You have a board fabrication defect. Search the web for "hole wall pullaway" Performing a microsection is the best way to analyze the defect.
Electronics Forum | Thu Oct 30 23:39:10 EDT 2014 | beilimanu
No paper thing, while I can make some suggestions based on my experience. what is the size of your via? If it's smaller than dia0.4mm, in PCB production process it should be filled by soldermask. So my suggestion is design it to be full filled by SM
Electronics Forum | Tue Nov 03 18:35:28 EST 2009 | gregoryyork
was this hasl finish looks like it has been corroded from the inside of the hole wall looking at the shape of the break in plating
Electronics Forum | Tue Oct 27 16:22:00 EDT 2009 | davef
It's not the first thing we think of in looking at your picture. First off, the lack of copper in the region of the red oval makes us think of a plating defect. We don't expect that moisture out-gassing through the barrel wall to show-up on opposite
Electronics Forum | Tue Feb 21 11:59:56 EST 2006 | dannyleach
We design a broad range of DC/DC power supplies for various telecom, internet, and computor applications and have been succesfully using intrusive reflow for ~7 years now. Our pcbs range from 0.065 to 0.090 in thickness and are moslty dense 4 to 8 la
Electronics Forum | Thu Nov 17 20:23:55 EST 2005 | davef
We're with your customer. We believe inner layer separation is not linked to a heating excursion. What you are seeing is separation between the hole wall and the copper plating in the barrel of the hole on an unstressed PTH. Although, it's possibl
Electronics Forum | Mon Oct 08 05:48:36 EDT 2012 | vinitverma
Dear Chris, N2324 and N2325 are for nozzle down sensors. THese sensors are located on the left and right side of the left and right walls of the head assembly respectively. There are very small holes in the walles through which these sensors transmi
Electronics Forum | Tue Nov 08 20:50:03 EST 2005 | davef
First, general comments about voiding in wave soldered connections are: * Causes of voids in solder connection are many: moisture, flux/paste volatiles, wave process, etc. * Impact on reliability of voids in a PTH solder connection is insignificant,
Electronics Forum | Mon Oct 31 13:31:19 EDT 2011 | davef
We're not sure what a 'sticky roller' is, but will it: * Remove ionic materials * Leave no residue * Clean the walls of through holes and vias * Clean under low stand-off BGA and LGA
Electronics Forum | Fri Dec 01 15:22:46 EST 2017 | kojotssss
Recommended land and solder pattern says: VIA wall plating, via holes should be tented with solder mask on the backside and filled with solder. Solutions at this moment ? Thanks for all :)
