Electronics Forum | Mon Jul 01 09:33:08 EDT 2019 | dbuschel
if you can't change the PCB materials or design at this point, you might be able to reduce it somewhat through the use of fixtures or edge stiffeners. Unless it is a particularly thick board, I don't think the reflow profile would be the issue. The t
Electronics Forum | Mon May 13 06:15:12 EDT 2019 | dhanish
how to control warpage on panelized pcb during reflow process.we are already running with pallet.Encountering problem to insert the pcb into pallet after first reflow cycle.The insertion is being done by robotic arm. Any recommendation on the profile
Electronics Forum | Thu May 17 19:21:39 EDT 2007 | diesel_1t
We are currently using Oven Rider (ECD) to "verify" just the conduct of the peak temperature; we define which product is the higher runner for this line and then with the settings for this product (already profiled with thermal couples attached to th
Electronics Forum | Tue Jun 21 20:45:53 EDT 2022 | stephendo
Are you talking about in the machine as in the blowers? Or the exhaust? When CFM is an issue with an oven I think exhaust. With the blowers I check the oven with a profiler. I would think that the geometry of the heaters and oven would affect how m
Electronics Forum | Thu Jun 30 13:33:23 EDT 2022 | emeto
Very interested what kind of profiler you use to check your profiles? KIC and Datapaqs have some predictors when it comes to reflow ovens or wave machines.
Electronics Forum | Mon Jun 27 14:44:47 EDT 2022 | kelvinchoong
Hi Sir, The VP Machine that i am currently using takes reference from its own temperature sensor. so most of the time i would have to adjust multiple times for my PCB to soak at the right temperature or reflow for the duration that i need it to. Fo
Electronics Forum | Mon Jun 27 12:02:47 EDT 2022 | proceng1
I have never used a VP oven, but I did get a pretty good demo of one and was pushing hard for my company to acquire one. The issue ended up being that there was not an East Coast distributor for the "juice" and that became cost prohibitive to get sh
Electronics Forum | Mon Jun 27 08:18:47 EDT 2022 | kelvinchoong
Hi All, Appreciate any inputs that may be given. Currently i am operating VP6000 Vapour Phase Reflow Oven from ASSCON. Over the last 2 years, we have around 100 different Recipes for many different PCBs. Each recipe is adjusted(6 Different Paramete
Electronics Forum | Fri Jun 03 04:16:27 EDT 2005 | Bryan She
Background: We use a thermal boards to setup/profiling the reflow oven for pilot run.and then daily verify the reflow profile with this thermal board.Now we phased into LF production,and the LF thermal board can only withstand 25~30 times reflow excu
Electronics Forum | Thu May 27 16:23:12 EDT 2004 | davef
Process Trials Procedures. Standard trials are often conducted on reflow ovens by production engineers during product assessment, machine approval or in process set-up. The following trials are also used by machine suppliers during equipment develop