Electronics Forum | Fri Aug 16 03:44:12 EDT 2013 | rollon65
Hi. Sorry I don't have an answer for this but I have the same problem in the "Y" axis on one of my 4Cs after the machine has run for around 4 hours. The machine seems to partially correct for the pick-ups being off as the placements are fairly good
Electronics Forum | Mon Jul 22 12:43:31 EDT 2013 | microaide
I don't think it is a loose camera lens. We are actually off on the position of the Z-rod. It's not just the camera position that is off. We really can't change nozzles because the z-rod misses the hole in the nozzle changer. We have repeatedly clea
Electronics Forum | Mon May 08 20:52:18 EDT 2000 | Dave F
Steve: A couple years ago, I decided that I needed to broaden my education in the areas(s) that I make my livelihood � soldering and assembly. I had attended some excellent (and some not so excellent) tutorials at NECON, but just felt I was missing
Electronics Forum | Fri Jan 20 12:46:21 EST 2012 | deanm
If 3-5% of the attempted parts placed are dropped, you have a serious problem...that's 1 part dropped for every 20 or 30 placements. Does it mean that it drops the part in the scrap bin and then successfully places the same part or would the board co
Electronics Forum | Mon Jan 21 06:58:41 EST 2019 | kiransahu
Without PCB layout, not much would get done. It is a ubiquitous need across industries; Industrial, consumer, military...Everywhere you look, there are chips soldered to PCBs to create a final product for the end customer. But where did we all learn
Electronics Forum | Mon Jul 16 21:39:40 EDT 2001 | davef
The method you suggest is about the only way to �clean-up� this terrible situation. Realistically, this is a "memory" type condition induced by design, build symmetry, "cross ply construction", excessive cool down rates during lamination or reflow a
Electronics Forum | Thu Nov 08 03:12:12 EST 2001 | Tom
I want to know the standard of component footprints, especially the dimensions of those component footprints. Where can I find the information?
Electronics Forum | Thu Nov 08 11:55:45 EST 2001 | davef
Consider searching the fine SMTnet Archives. For instance look at the following thread: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=18112
Electronics Forum | Fri Nov 16 10:22:51 EST 2001 | Steve
Try IPC-SM-782A,Surface Mount Design and Land Pattern Standard. Go to http://www.ipc.org
Electronics Forum | Tue Nov 10 19:12:10 EST 2015 | billthebuilder
I am trying to make a PCB populated with complex components such as LGA, WLBGA, LGFP, LFCSP, VFBGA, QFN, FBGA, PBGA so that we can test out some PnP machines. I have found parts on digikey for each of the packages we want to test but trying to make
.gif)
winsouce.jpg)
