Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm
Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default
Electronics Forum | Tue Nov 01 16:09:38 EDT 2022 | kamedatec
The machine had the Auto Tray installed but was removed to put here in the company because the machine was bigger than my elevator. The owner told me it was working, which made me waste time testing all possible settings, electronic cards and cables.
Electronics Forum | Thu Aug 09 16:51:39 EDT 2018 | tey422
A good set of fixtures are what you need to get it done right. Since we are in the same area, I would recommend give ATD (Advance Tooling Design)a try, they located in San Jose. We been using fixtures from them for years. We build thousands of Fle
Electronics Forum | Fri Aug 10 18:31:10 EDT 2018 | ks0707
Absolutely I will share the solution with you if I find something. Thomas, thank you for your help. Have a great weekend!
Electronics Forum | Fri Aug 10 18:17:43 EDT 2018 | tey422
I am sorry to hear that they are unable to help you out too. If you do came up with the doable solution later, be sure to let me know about it too. I would like to learn new trick or knowing which house that can handle such task.
Electronics Forum | Thu Aug 05 17:32:31 EDT 2021 | cyber_wolf
Including non-spring tools ? Additionally I assume you know how to use the tool install utility and have looked for things like cracks in the big ribbon cables on the X ? Tools are not dry and have white grease on them etc ? There is a show force
Electronics Forum | Thu Aug 09 09:14:22 EDT 2018 | ks0707
Is there any special machines/equipment which are able to install FBGA parts on the very thin flex boards for Printing, Pick & Place, and Reflow ? Q2> Is there any Fixture house who can offer fixtures to enable SMT processes for those assemblies ? Q
Electronics Forum | Thu Aug 09 16:24:27 EDT 2018 | ks0707
Hi Thomas, Thank you for your posting and I agree with you that Printing is the most difficult one. BTW, after you ran the one side (let's say Bottom side), my engineer worries about the distortion of flex board because of the thickness. In that ca
Electronics Forum | Thu Aug 09 14:00:51 EDT 2018 | tey422
To me the most challenge would be the printing step. If you can print it, you should able to run it with SMT. We ran similar thickness flex boards before. But it's long flex with small stiffener at both ends, and it was 10up array. You need fixture
winsouce.jpg)