Electronics Forum | Fri Jun 03 04:16:27 EDT 2005 | Bryan She
Background: We use a thermal boards to setup/profiling the reflow oven for pilot run.and then daily verify the reflow profile with this thermal board.Now we phased into LF production,and the LF thermal board can only withstand 25~30 times reflow excu
Electronics Forum | Mon Jul 04 14:21:14 EDT 2011 | davef
The three primary causes for bubble generation in solvent-based coatings are: * Air entrapment * Solvent flash-off * Curing the coating too quickly Tell us more about your process including: * When you first notice the bubbles * Extent of the probl
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
Electronics Forum | Fri Jun 03 09:00:06 EDT 2005 | russ
How many times have you found that your oven was performing differently? this will give you the answer on frequency. We have a dedicated board and profile that we use to verify the oven operation. We perform this every 3 mos. and I believe that th
Electronics Forum | Mon Jun 13 16:15:04 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Mon Jun 13 16:17:30 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Tue Jun 14 15:03:15 EDT 2005 | slthomas
In that the machine times out and waits for a feeder refill and doesn't just skip that part and leave the space empty, it's not a defect. I have found 500ppm *fairly* easily attained in SMT depending on the board mix and how you define (1) a defect,
Electronics Forum | Tue Jun 14 16:37:56 EDT 2005 | slthomas
You may be right. I may have read something into his post that wasn't there....
Electronics Forum | Tue Jun 14 16:21:15 EDT 2005 | pr
My chipshooter will not "Time out", it will try to pick 3x and then alert the operator. Which would be 3 misses per empty reel. Unless I misread his post, he said 500 ppm at the placement machine. That makes a big difference.
Electronics Forum | Wed Jun 15 00:50:32 EDT 2005 | Frank
From my understanding: Sigma is the same as one standard deviation. So 3 sigma is the same as 3 standard deviations. It all boils down to how repeatable your machine is. Another way to look at it is the probability (or confidence) that the machin