Electronics Forum | Thu Dec 23 22:31:47 EST 1999 | Vincent Chen
Hi!Charlie, 1.Are you retrofitting your spray fluxer in your wave soldering machine? If you are, please ensure that you have a air knife just before the preheater!Fluxe fumes tends to accumulate and that could be dangerous if your air exhaust is not
Electronics Forum | Thu Oct 08 12:02:15 EDT 1998 | Bernardo Mendoza
I need to set a cleanliness limit for our incoming boards. I know that some people use 14-10 microgr. sq. in. But how can I determine what is best for me. Can anybody tell me if there's a standard for this. Right now we are using an Alpha Ionograph
Electronics Forum | Fri Oct 09 14:29:07 EDT 1998 | Chrys
| I need to set a cleanliness limit for our incoming boards. I know that some people use 14-10 microgr. sq. in. But how can I determine what is best for me. | Can anybody tell me if there's a standard for this. | Right now we are using an Alpha Iono
Electronics Forum | Fri Oct 09 23:17:05 EDT 1998 | kallol Chakraborty
| | I need to set a cleanliness limit for our incoming boards. I know that some people use 14-10 microgr. sq. in. But how can I determine what is best for me. | | Can anybody tell me if there's a standard for this. | | Right now we are using an Alph
Electronics Forum | Mon Jun 13 16:15:04 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Mon Jun 13 16:17:30 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
Electronics Forum | Tue Feb 28 03:33:29 EST 2006 | snowcaj
To set warm-up time,which standard should we select and how should we measure? Thanks!
Electronics Forum | Tue Feb 28 13:46:28 EST 2006 | slthomas
Assuming you're using DOM and shelf life to determine what's good and what's not, you just have to know 1)the rate at which you use it up, 2) how much shelf life is left, and 3) the rate that it goes bad when not refrigerated. From that you can tel
Electronics Forum | Wed Aug 04 14:23:06 EDT 1999 | Dave F
| Jim McCarten and Dave F, | | Jim - How about a little explanation on your PlacePro 7100 comments? I'd like to know what a "typical SMT board" is and how "thruput is cut in half" by assembling it. Is this typical SMT board something that most manuf
