Electronics Forum | Sat Feb 17 21:46:26 EST 2001 | edmo
I am the new user for siplace HS50 for about 3 months, running 24 hours production. I used to perform PM every 2 weeks. I have just changed all the plungers(Alu) and nozzles(904) and some nozzle sleeves due to components high throw-out. The estimat
Electronics Forum | Sun Feb 18 14:46:11 EST 2001 | CAL
Some key data is needed 1) how often does the HS 50 machines run? 24/7? 2)How many placements are being performed? I know for a fact Siemens Siplace S/F platforms require weekly preventative maintenance. Knowing the sophistication of the HS platform
Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Sun Jan 23 00:57:23 EST 2011 | bvdb
Hi Jerry, Happy New Year. Thanks for your suggestions. You were on the right track because I remembered that one of the last things that happened before the error message started showing up was that I cut and removed the empty tape from the back o
Electronics Forum | Tue Mar 14 17:05:45 EDT 2023 | helder_remelhe
Actually we have problem in an machine Samsung SM411. the machine stop the in Initializing machine I/F. i tried remove the VME-PCI and clean the connector and put again, change the CAn board and the result is the same. someone have an ideia of the
Electronics Forum | Fri Mar 17 11:29:45 EDT 2023 | proceng1
Do you get an error message? IS there a code? Will it initialize again, but just stop? Or is it dead now?
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Wed Dec 23 19:50:28 EST 2020 | ttheis
Thanks; I have a spare power supply coming as well. I will start by swapping dc-dc converters first and if the problem persists swap the pdp power supply. I'll report back what I find.
.gif)
winsouce.jpg)