Electronics Forum | Wed Feb 10 08:10:26 EST 2010 | davef
Here is a posting by P Kinner at Humiseal ... Typically, there are three main approaches to avoid coating wicking into press-fit connectors (and other keep out areas). Wicking is a phenomenon caused by a combination of low viscosity of conformal coa
Electronics Forum | Thu Mar 31 10:14:06 EST 2005 | davef
There's some nice low-VOC uV coatings out there. We don�t use uV cured coatings, but try: * http://www.emersoncuming.com * http://www.dymax.com * http://www.mgchemicals.com * http://www.loctite.com * http://www.humiseal.com Be aware that uV co
Electronics Forum | Thu Dec 10 15:33:55 EST 2009 | duso02
We use one quite often. Our machine is a Uvitron Conveyor 40 as we are a large coating house and this allows us to process many boards. Dymax also maufactures and sells machines as well. Humiseal and Dymax both manufacture UV coatings. Emerson Cuming
Electronics Forum | Wed Feb 28 20:10:08 EST 2001 | mhunter
Checked the archives with no luck. Anyone have a reliable test method of verifying acrylic conformal coat cure. Using Humiseal 1B31 mixed with approximately 30% solvent, spraying with a Nordson. Thanks in advance.
Electronics Forum | Wed Feb 28 20:16:26 EST 2001 | mhunter
Checked the archives with no luck. Anyone have a reliable test method of verifying acrylic conformal coat cure. Using Humiseal 1B31 mixed with approximately 30% solvent, spraying with a Nordson. Thanks in advance.
Electronics Forum | Fri Apr 17 14:08:00 EDT 2015 | davef
Humiseal says, "UV cure – These materials are also more difficult to repair as they are the most chemically resistant and mechanically tough of all conformal coatings. Removal is possible locally by using powder abrasion."
Electronics Forum | Mon Jun 25 12:23:15 EDT 2007 | davef
Once the HumiSeal conformal coating has been applied to the printed circuit board it is usually best to allow the material to reach a touch-dry stage, before heating the board to accelerate the cure schedule. This avoids potential problems such as bu
Electronics Forum | Wed Apr 30 15:00:51 EDT 2008 | mikesewell
I believe Humiseal (and others) makes some water based coatings...www.humiseal.com Dymax has a no VOC UV cure if you have an adequate UV source.
Electronics Forum | Mon Sep 28 12:25:13 EDT 2009 | vleasher
Could someone point me in the direction of some good manufactures of batch style curing ovens? We have a new project requiring Humiseal 2A64 and we do not have an oven for the 3hrs @ 170F cure. Thanks in advance!
Electronics Forum | Fri Aug 07 16:45:35 EDT 2020 | duso02
All URs require a long time to fully cure. And actually, most users do not reach full-cure before using the board. Even Humiseal 1A33 will be dry enough to handle after a very short time.