Electronics Forum | Sat Feb 22 09:47:44 EST 2020 | tomdegas
When I run the "Service" software and I look at the status of the HYDB in the Utilities tab, it comes back with all is good except that the Hydra motor temperature sensor is "disconnected". Can anyone tell me where this sensor is and is it replaceabl
Electronics Forum | Thu Nov 10 18:58:38 EST 2005 | darby
What is the problem Peter? See a recent posting on a Y axis problem with the same style of machine. If the encoder is cactus, buy a new motor. Sorry, this is the only solution I know of.
Electronics Forum | Thu Nov 10 10:03:38 EST 2005 | meritajs
Hi, May be somebody know how we could adjust optical shaft encoder at YAMAHA 84 mounter Thank Peter
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
Electronics Forum | Mon Dec 26 18:02:37 EST 2022 | rgduval
So, your Hydra Z message timed out... A couple of potential causes: 1. Hydra MOT card failure 2. Hydra z-motor failure 3. Hydra z-motor encoder failure 4. Hydra z-lock failure 5. Disconnected cable 6. X-wagon cable Start by booting into service mod
Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk
That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa
Electronics Forum | Thu Jan 29 15:57:09 EST 2009 | evtimov
Hi If it is a DC motor just turn the power wires and exchange the sensors. emil
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
winsouce.jpg)
