Electronics Forum | Sat Aug 01 02:30:23 EDT 2015 | sarason
You could take a piece of aircraft grade aluminium, and machine you own. the advantage is you can set it up so you don't have to do any height compensation when you swap between a normal board, and your custom assembly sarason
Electronics Forum | Sat Aug 01 03:52:54 EDT 2015 | mikekeens
I have had some custom support jigs made but as i'm working for a contract electronics manufacturer there are so many different PCB assemblies to be made - storage of the different jigs and the changeover time is the problem. The support system ne
Electronics Forum | Thu Jul 30 08:46:12 EDT 2015 | hemantp
We are having X-Ray Machine X TEK HMXST-160 The machine is working fine with respect to Interlocking , X-ray on , but not able to zoom and move the Joystick positions ,it is stand only in one position while starting the application we are getting
Electronics Forum | Thu Jul 30 10:59:05 EDT 2015 | emeto
Hi, I had similar problem on my Dage X-ray machine. I had to reinstall the firmware for the Nextmove card. Check your CDs you have with the machine and you should have a software(and manuals) which you will use to reinstall the firmware on your cont
Electronics Forum | Thu Jul 30 16:50:41 EDT 2015 | lokit
In our production line we use the pick and placer My100 by Mycronics. We get a lot of feedback from quality department about IC's being placed upside down, wrong polarity. (Wrong polarity usually already delivered to us, or IC's placed in the sticks
Electronics Forum | Wed Aug 19 03:24:49 EDT 2015 | pcbman
I ordered few times of prototyping gold plating > pcb from China. How to i differentiate they are > ENIG or Flash gold? Hi,Friend , this is very easy to distinguish the ENIG and gold plating pcb, you can stratch the solder mask off and see the co
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Tue Aug 04 23:50:20 EDT 2015 | johnwnz
Hi folks, I was wondering what the combined wisdom was on the humidity effect on the MSD control required by the Jedec std. The std works on a relative humidity of 65%, if my RH is only say 30% because of factory environments how do I easily factor
Electronics Forum | Wed Aug 05 12:31:57 EDT 2015 | swiese242
As the industry moves forward it is now optimal and imperative to have this option of inspection. We currently have a used Glenbrook RTX-2500 model that we picked up at an auction and is next on list to replace with a better machine. It works fine fo