Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Mon Aug 04 04:58:23 EDT 2008 | stiva
Hi Sound like the same problem that i had. The machine after it had warmed up when initialising would drive the z rod down with the quadalign on checking for the nozzle height (I think). To me it seemed like an overheating problem as after allowin
Electronics Forum | Mon Feb 04 08:04:39 EST 2013 | marcelorotofrance
Function 30 reads CENTER 1024 RUN OUT 0.0 with any nozzle and without nozzle at all. However I see that nozzle tip stops in front of laser beam. When I interrupt the beam with a piece of paper during Function 30, Z axis travels down until I take it
Electronics Forum | Wed Sep 20 18:12:07 EDT 2006 | lheiss
I forgot to ask if anyone knows what numbers I should get for function 30, nozzle height and center of rotation? I'm getting 365 for height and 12314 for center of rotation. I know it isn't 12.314 inches out!
Electronics Forum | Wed Aug 05 08:16:34 EDT 2015 | emeto
Hi, that's how it works: 1. Zoom to the object you want to start with. 2. Click S to center to the object. Depending on the zoom you can center to pad, line, corner.... 3. Click Z(this zeroes your Relative coordinates). If you click Ctrl+z(this ze
Electronics Forum | Tue Apr 05 12:01:17 EDT 2005 | blueflag
Thanks for reply we have found a blown fuse on the back plane for the mot-z pcb . But we now have problems with Z height, i am trying to auto-teach devices from the tray wagon (qfp etc) and it is not always lowering the nozzle to the component. i ha
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Thu Sep 08 18:10:09 EDT 2022 | mt396596
We just went through a similar issue with our MY12E. Make sure your Midas vacuum system is working, check your Midas Z friction. Also verify the Centering unit centering band. You can swap your MOTZ and MOTC to rule out the card. The tool install t
Electronics Forum | Sat Jun 12 10:46:32 EDT 1999 | Dean
| Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from manufac
Electronics Forum | Wed Apr 06 05:08:07 EDT 2005 | blueflag
New morning but still the same agro'. The story so far - Have checked the fuse on the back plane and it had blown again, changed it has been ok. Swapped the mot-z board around with piggyback mi card, no new other/moved problems. When doing base cente
