Electronics Forum | Wed Jan 05 09:44:45 EST 2000 | Millerin Claude
Some PCB's manufacturers are now able to fill the hole and then re-metallized the pattern in order to obtain a final soldering surface perfectly flat but with an electrical connection under. This of course increase the price of the pcb but avoid any
Electronics Forum | Tue Mar 24 11:20:18 EST 1998 | Earl Moon
| Anyone have an idea how small a via must be to inhibit significant solder volume escaping into the via? Typically, micro vias are drilled and plated to about .003" diameter. To avoid significant solder "drain off," they should be drilled as shallow
Electronics Forum | Wed Mar 25 19:41:01 EST 1998 | Earl Moon
| We have successfully put .016" vias in .030" pads. | There is no drain off with .030" solder balls, since | the actual volume in the .002" depression is low. | We did notice random bubbles where, apparently, the | solder reflowed and trapped the a
Electronics Forum | Wed Mar 25 16:38:21 EST 1998 | Steve Joy
We have successfully put .016" vias in .030" pads. There is no issue with .030" solder balls, since the actual volume of the .002" via in pad is small compared to the ball+solder paste volume. We did notice random bubbles where, apparently, the sol
Electronics Forum | Wed Mar 25 16:36:10 EST 1998 | Steve Joy
We have successfully put .016" vias in .030" pads. There is no drain off with .030" solder balls, since the actual volume in the .002" depression is low. We did notice random bubbles where, apparently, the solder reflowed and trapped the air in the
Electronics Forum | Mon Apr 05 16:12:16 EDT 2010 | dyoungquist
We are installing via reflow soldering a crystal that has 2 pads, 1 each end. They are flat pads on the bottom of the part with a small area of the pad looping around and up the side of the crystal on the end. Inspection of the cyrstal under a 40X
| 1 |
