Electronics Forum | Thu Nov 07 10:07:02 EST 2019 | charliedci
Requesting help from anyone with experience in reflowing Te Connect, PN 1565917-4, 200 pin connecter. Pic attached. Cannot get all 200 pins to wet, main suspect is slight PCB warping during reflow. Have adjusted reflow profile. A 2.75 inch long SMT c
Electronics Forum | Thu Dec 27 09:56:36 EST 2012 | swag
100 sec.). If I keep TAL closer to where I like it to be, peaks are all low; around 200C to 205C. If I can't find a happy medium between TAL and PEAK, what should I consider doing?
Electronics Forum | Wed Mar 21 11:42:54 EDT 2012 | davef
Downhole solder suggestions, in order of preference are: * Kester Sn96.3Ag3.7. Most vendors do not stock straight tin-silver alloys, whose wallet is that fat? * SAC305 can usually be used in place of one of the copper-free tin-silver alloys in downho
Electronics Forum | Wed May 29 12:55:33 EDT 2024 | mistrthou
Curious if anyone out there has a VIP 200 heat shrink applicator laying about. We have 2 that we still use and are looking to have them rebuilt or re-engineered and we'd like a 3rd to be able to disassemble. I know a lot of you have harness assembly
Electronics Forum | Fri May 03 13:31:28 EDT 2002 | fastek
I agree with Sai regarding re-sale. It's night and day with Fuji vs. Philips. You can't imagine how cheap FCM-2's are going for these days. I've got a 2000 model with 200 hours on it (basically a new machine) and over 100 feeders available for very l
Electronics Forum | Fri Nov 07 16:28:05 EST 2014 | nathanhawks12
For best 2-32 layers PCB Prototypes prices visit http://www.rushpcb.com or http://www.rushpcb.co.uk
Electronics Forum | Tue Jan 03 12:33:23 EST 2023 | stephendo
Is there any RS232 to USB involved with the machine? I'm guessing that it is a new to you machine that had been running before you bought it. We had an oven like that that would not find the machine. I noticed that a setting had been 2 then later w
Electronics Forum | Thu Aug 04 14:01:56 EDT 2022 | ttheis
We are having an issue with a Jade S200 we recently purchased. When opening the pillarcom software it is unable to establish communication with the machine. The power supplies and fuses all seem to be ok and at proper voltages. Checked as many connec
Electronics Forum | Thu Aug 04 21:51:45 EDT 2022 | ttheis
When I press the green start-cycle button the 42V=E light illuminates but the 24V=E light does not. Could this be related?
Electronics Forum | Sat Dec 31 00:52:33 EST 2022 | sarason
Next step trace the RS232 cable. Check all output voltages on your power supplys, b oth loaded an d unloaded. Note any differences. Check he impedancesa of your loads ie is your 24 volt load only measuring a few ohms. You may have a short? sarason
