Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Thu Oct 20 19:23:18 EDT 2011 | eadthem
As far as the buttons go, White = pause for inspection when depressed, lit when active Green = pass after inspection when lit you need to press the button, when flashing its waiting for the upline machine, Yellow/orange = when flashing indicates
Electronics Forum | Wed Aug 22 08:30:02 EDT 2007 | davef
Could there be a vibration on or jamming of the conveyor of your oven that is causing these parts to tip-over?
Electronics Forum | Wed May 02 09:25:09 EDT 2012 | tbouslog
Our company has recently changed the way our cage gives our SMT Department their parts to try to better control inventory. SMT now instead of recieving reels recieves strips with only 2-20 extra parts depending and the size/cost of the part. Does any
Electronics Forum | Thu Jun 16 22:18:35 EDT 2005 | davef
Cooling may require muff fans positioned over that output conveyor of the oven.
Electronics Forum | Mon Oct 07 23:04:05 EDT 2019 | SMTA-David
Hi, I have a semi-Auto paste stencil machine and use laser cut stainless stencil with T4 paste. When I start pasting boards the paste covers the pads and is well defined. Throughout the job we have been having some issues with feeder on pick and pl
Electronics Forum | Sat Jun 12 00:34:00 EDT 2004 | kanwal324
Hi ! The main problem being faced currently is formation of solder balls - to be precise, these are micro solder beads generally found attached with bodies of SOTs, Chip Caps, Chip Resistors, between pins of SOICs (50 mil) - lying on PCB surface,
Electronics Forum | Mon Jun 21 11:14:25 EDT 2004 | exmaintenanceleader
Dear Kanwaljit Singh, my opinion is following: 1)solderpaste type is ok - usual (alpha-metals has this problem inside the paste paste- holder problem) - what do the operator when production change -clean well the stencil holes!! no visible rest on
Electronics Forum | Tue Mar 30 14:59:00 EST 2004 | Claude_Couture
no help from BTU, didn't buy from them so no support. I found the cause of the problem. The input of the controler relating to the conveyor alarm must have been stuck. By toggling the trigger value from Lo to High in the setup screen, I caused an ala
Electronics Forum | Thu Feb 22 23:27:14 EST 2007 | dekhead
If protocol is already manual, does conveyor start when "RUN" is pressed (without board on rail)? Or does it not start until board is placed? Try running UL protocol as "No FMI", put in run without board on rails, place board, press "Confirm". Board
.gif)
