Electronics Forum | Wed Mar 07 20:37:38 EST 2001 | davef
I agree. The bar coded label you use should not be affected by the solder mask of the board. The label should have sharp contrast between the segments of the code to modulate the returned light and allow the reader to discriminate between light and
Electronics Forum | Thu Mar 08 09:38:35 EST 2001 | blnorman
We've been using pre-printed labels on our PCB's for years, with 8 - 10 hours a week down time associated with them. Last October we put a CO2 laser marker on one of our lines. In 6 months we've had a total of 30 minutes down time. We use a 2D b
Electronics Forum | Wed Apr 27 06:57:47 EDT 2005 | steve
I always have a difficult time with seeing people using two different manufacturers products. Here your printing with Senju and hand soldering with Kester. So if theres a problem you have to look at two different products, contact two different compa
Electronics Forum | Sat Apr 30 13:56:31 EDT 2005 | steve
My experience with different size boards and pre-heaters. The perfect world (right?) you would saturate the complete pcb with bottom pre-heat. But it is difficult with repair and rework equipment, not to mention the expense and foot print of large pr
Electronics Forum | Mon Apr 17 19:44:20 EDT 2000 | Dave F
Ashok: Well, your customer probably has a good reason for wanting you to send them boards without holes in the solder mask. What is their goal for the mask capabilities after you get do reworking the boards? * Cosmetic surface coat? * Performance t
Electronics Forum | Thu Nov 14 08:53:44 EST 2002 | MA/NY DDave
Hi As DaveF suggested I would contact a shop that has done repair. You should have the PCB/PWB Print and laminate information with you when you make the call. Ask the repair shops if they have continual experience with the Rogers Material you are us
Electronics Forum | Wed Nov 13 22:30:05 EST 2002 | davef
Methods for performing repairs: * 7721 - Repair & Modification of Printed Boards & Electronic Assemblies. * On-line guides at Circuit Repair Technology [ http://www.circuittechctr.com ] site. Roughly from East to West, service companies that perfor
Electronics Forum | Fri Jan 28 19:26:51 EST 2011 | jlawson
Milara has a combined Stencil printer + jet Printing ??? Print and then jet print areas not printed or top up prints.
Electronics Forum | Wed May 25 23:45:04 EDT 2022 | SMTA-64387687
1. The jetting head flies very low to the level of the board. So, performing AOI function will crash the head. 2. AOI is performed close to the end of the line, after P&P or reflow. Are you planning to run the boards back-and-forth, on the line? 3. L
Electronics Forum | Thu Aug 06 14:58:40 EDT 2009 | davef
Semiconductor fab back-ends and production contractors use laser assisted solder jetting for protoyping, repair, and other low volume flip chip bumping. * As you say, printing paste is going to be very tough to control. * Solid ball placement is ai