Electronics Forum | Thu Dec 08 16:02:35 EST 2005 | PWH
Not sure how Juki centernests operate but baybe the board thickness is prgrammed wrong and the top board surface is too low or too high (bowed upward). This will cause bad placements. This is an easy mistake to make on HSP.
Electronics Forum | Sat Mar 28 06:45:31 EDT 2020 | aswa1111
Hey everyone, I hope all of you doing well this time of the year. We have an old Juki / Zevatech 740 pick and place machine and we got a problem with the vision alignment, every placement is off by 2mils. How can you run an offset calibration on t
Electronics Forum | Thu Dec 08 11:50:40 EST 2005 | Stefan
If you mention mis-alignment and missing component in the same sentance, I suspect the component is not properly released after placement. Assuming the Juki machines use an air blow, after vacuum shut off, than I would look at a correct air flow firs
Electronics Forum | Sun Mar 10 16:16:35 EDT 2019 | sam512bb
Good day All, I was curious if anyone has a source for Juki/Zevatech PM575 Calibration jigs? My machine's placement is off and various a bit and so it was recommended to calibration the laser alignment. Sadly, there are no service centers located a
Electronics Forum | Mon Aug 01 08:54:39 EDT 2022 | spoiltforchoice
You should get good service support and reliability from all of them, provided your local distribution agent is a good one. In the UK for instance I would trust all 3 on that front but I would expect very different support pricing structures. Any ma
Electronics Forum | Sun Jan 30 20:13:32 EST 2022 | chuckphd53
I have a SMT-460 machine that works pretty good for the most part. When placing parts I have an issue with the SOT-23 rotation 90deg. Using both Juki 503 / 504 nozzle it will pick and place all of the 0805 and 1206 resistors/caps just fine. I have 9
1 |