Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Tue Oct 20 23:14:01 EDT 2015 | kiwiguy12345
Hi, I have struck a problem with the X axis on my Juki 740. As soon as I "home" the machine the X driver displays the code "961" Does anyone have any ideas as to a solution for this problem? Thanks!
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Sat Aug 26 21:53:47 EDT 2017 | kieren
Hi Everyone. I am looking for some help with my Juki Ke750. The problem is that after booting up and then starting the home position function I receive an error as stated below Message File Error E0000: KEY=200078 STATUS=2 C:￥X750 ￥GX3ERROR。MSG
Electronics Forum | Tue Jun 18 09:02:02 EDT 2013 | leeg
We are having issues on our 750 machine with the following errors, E240015 and E240021 this can occur on any of the 3 heads therefore surely ruling out Laser issues with 1 particular head?
Electronics Forum | Mon Jul 11 21:46:19 EDT 2011 | garym4569
Anyone know how to enable pick tracking for the Juki 730 and 760. Our Juki 750's and 2060 allow me to press the camera button during a production stop to manually check pick position with the camera if the machine stops for no component, laser recon
Electronics Forum | Sat Oct 21 17:41:05 EDT 2023 | basil_rv
Hi all! While operating the JUKI JX-350LED, error E600016 (Since the Z-axis is descending, it cannot operate) appeared. During initialization, this error appears, although all heads are raised. Rebooting and turning off the heads did not help. Wha
