Electronics Forum | Mon Nov 19 05:16:02 EST 2012 | ericrr
Thank you ENIAC for your comments Here is another problem (JUKI KE-750L) Which applies to 0603 (1608 metric) resistors and only resistors (mind you the board is more heavily populated with resistors) After the panel has gone through the oven, Wh
Electronics Forum | Tue Mar 19 07:04:21 EDT 2013 | Flux Capacitor
When I enter in the program data for a particular PCB on our Juki, I choose a board fiducial and enter its X Y location as the "bad mark position". (Although I'm not sure if your model refers to this as a "bad mark" as well.) Place a sticker over tha
Electronics Forum | Wed Apr 27 03:19:21 EDT 2022 | jojoled
Hi, bought older yet good JUKI machine, but can not make it work, due to lack of explanation of PWB editing details in manuals, hopefully someone can help : - what is BOC mark - how is the "PWB centering pin" normally used? - What is "Hole reference
Electronics Forum | Wed Jul 04 09:54:07 EDT 2007 | timstevenson
I have posted on the advert site the my need for this camera. All the responses are from off shore and I am hesitant to deal with someone where their is no chance for recourse . Does anyone know a North American source for this camera ? Juki sells it
Electronics Forum | Mon Dec 10 13:23:51 EST 2012 | ericrr
Thank you ENIAC for your input. The engineer who did the PCB says all his figures are correct. I over came the problem by moving the X coordinateness of the 2nd BOC mark (top left on the picture) over just slightly in the file (measured by the dis
Electronics Forum | Mon Aug 05 18:17:31 EDT 2013 | starlogixs
No the actual Juki software for the machine. Need to calibrate the machine after a motor replacement. Regards Mark
Electronics Forum | Mon Aug 05 22:55:33 EDT 2013 | starlogixs
Thanks Sarson. Thats the one I'm trying to buy, but it has this missing software. Regards Mark
Electronics Forum | Sun Aug 04 19:42:50 EDT 2013 | starlogixs
Thanks for the reply Sarason. The software looks interesting, as we are a small manufacturer. However I do need the original Juki software for a calibration file. The X axis motor has been replaced but the calibration file is missing to teach and ca
Electronics Forum | Wed Nov 21 15:37:46 EST 2007 | afm
We have been looking for an old machine (budget issues), and we have foud Juki 570L and Quad IVc to be around same cost. I have found some comments on the forum for the Quad (good in general), but not too much for the Juki. Beside the expected issues
Electronics Forum | Wed Nov 28 12:29:22 EST 2007 | gregp
Try serarching under Zevatech 570 instead. Or contact me for some alternatives (factory rebuilt machines available). Greg