Electronics Forum | Thu Sep 19 16:58:04 EDT 2002 | dragonslayr
You definitely need to have live demos of each system, using your specific assembly if you want to compare apples to apples. Each of the AOI OEM's you mentioned have plus amd minus to their unique systems. You will need to evaluate your specific nee
Electronics Forum | Fri Sep 20 14:23:50 EDT 2002 | larryk
PizzaFred, Scott mentioned lots of good ideas. Take one of your boards to each vendor and see what it takes to program the board how long it takes for it to become online. I've found some that are easy to program, but require 40 or more assemblies to
Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Tue Aug 21 21:11:29 EDT 2001 | davef
It depends on what you're doing. Say for component placement verification, a line that's kicking-butt might have time to look at a somewhat different quarter of each board, depending on lots of stuff [eg, board, AOI equipment, line rate, etc.]
Electronics Forum | Thu Aug 23 21:00:10 EDT 2001 | davef
We do the same quadrent every four boards in placement inspection on a Orbotech.
Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Fri Aug 03 09:21:08 EDT 2001 | Ian T
hi my company is planing to purchase an aoi system to be used inline. is there anyone out there doing this, if so do you use all the machine options (pattern character recognition, bad board marks, correct part polarity...) or do you dumb it down(pa
Electronics Forum | Wed Jan 24 21:29:43 EST 2007 | davef
Board fabricators commonly use Barco AOI to inspect film. The AccuMatch compares pixel-to-pixel of the Gerber data to the image seen by the AOI camera. It's slower than design rule checking, but has definite advantages [like lower falsing]. Unfortu
Electronics Forum | Wed Aug 22 12:30:34 EDT 2001 | slthomas
Now that's an approach I've never thought of, inspecting a different portion of each board (I'm assuming that you program a few different patterns and run them sequencially, or something like that). I know our stencil printers don't provide that opti
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
.gif)
.gif)
