Electronics Forum | Tue Nov 20 11:01:05 EST 2007 | dstevenson
Is anyone using a laser to selectively solder components to a board? I'm just starting to research selective soldering methods for the company i work for as we're looking to replace our current hand soldering processes for lead- and lead free- produ
Electronics Forum | Fri Oct 07 12:50:51 EDT 2016 | padawanlinuxero
Hello guys I am back! Guys I have a problem with the laser marker here, we use the laser to mark a 2D barcode on the pcbs for traceability, but for some reason since yesterday every time it tries to connect to the database to get the serial codes an
Electronics Forum | Fri May 11 03:55:22 EDT 2007 | lupo
Hi everybody, Please could anyone shed any light on the subject: resistance laser cutting with flux- calibration of LEDs during electronic assembly phase. Should special equipments be used? What is exactly the process? Thanks and Regards,
Electronics Forum | Fri Dec 09 08:24:48 EST 2005 | zanolli
Dear Technetters We have a unique soldering operation that needs automation and we will be evaluating various methods including laser reflow and Spirig�s Microflame. The actual soldering operation entails joing two metal contacts by depositing a sol
Electronics Forum | Fri May 11 10:48:51 EDT 2007 | Rob
Hi Lupo, Are you talking about laser trimming the current limiting resistors in front of the LEDs, whilst dynamically measuring their output to get set light levels? If so then you need a laser trimmer & a very good photodiode/comparator feedback l
Electronics Forum | Thu Jun 28 09:11:19 EDT 2012 | davef
I though this was a good article on picking a part numbering scheme and since you weren't getting any takes figured I throw this out there and maybe get a conversation going. Part number system: How to get started Filed under: Item and File Man
Electronics Forum | Tue May 01 09:58:20 EDT 2007 | rgduval
Basem, I can't direct you to a dispensing machine, as I'm not familiar with them. But, I can tell you what we do. We specialize in short volume, prototype quantity runs. Since prototypes and short quantities are not conducive to volume operations
Electronics Forum | Fri Apr 12 10:15:12 EDT 2002 | dima
Hi! I investigate possibility of manufacturing laser cut stencils. May be someone knows about equipment suppliers for such production (lasers, e.c.t.)? Thank you in advance for your help!
Electronics Forum | Sat Apr 13 12:54:39 EDT 2002 | dima
Thank you Dave! Very usefull information, very detailed. Thanks once again! Dmitry
Electronics Forum | Sun Apr 14 14:13:25 EDT 2002 | davef
I assume you're looking at stencil fab equipment because you need 'faster turns' than you can get from available stencil suppliers. While you're assessing this, consider other alternatives, such as: * Dispensing paste. [A very funny SMTNetter, livin
winsouce.jpg)