Electronics Forum | Wed Feb 16 20:51:37 EST 2000 | Jim
We have to place some LCC208's. The terminations are flush with the underside of the package, on an 0.5mm pitch. The pads on the board are flat tin. We'd like to get the part up in the air a little to provide some clearance for cleaning. Is there a w
Electronics Forum | Wed Feb 16 20:51:37 EST 2000 | Jim
We have to place some LCC208's. The terminations are flush with the underside of the package, on an 0.5mm pitch. The pads on the board are flat tin. We'd like to get the part up in the air a little to provide some clearance for cleaning. Is there a w
Electronics Forum | Sun Sep 26 14:09:24 EDT 1999 | jgodfrey
| | I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than sp
Electronics Forum | Fri Sep 24 23:33:30 EDT 1999 | Earl Moon
| I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than spac
Electronics Forum | Fri Sep 24 11:38:32 EDT 1999 | danielm
I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than space
Electronics Forum | Mon Sep 27 04:08:25 EDT 1999 | Earl Moon
| | | I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than
Electronics Forum | Tue Jun 10 17:13:44 EDT 2014 | grauen06
I have seen this on a MyDATA machine and we had to slow our feed rate of the feeder down. That seemed to do the trick. We concluded the carrier tape was too large for the part, but our vendor didn't really seem to care.
Electronics Forum | Fri Sep 07 07:39:11 EDT 2001 | caldon
Can you confirm the components are being picked up from the feeders? If the Feeder table calibration is incorrect the components could be picked up off from the begining. This would result in 1) nozzle barely picking up the part and as the head moves
Electronics Forum | Tue Feb 28 16:58:39 EST 2006 | PWH
Too fast heating/cooling rate in reflow (look at mfg's spec.). Z "overdrive" on pick and place or chipshooter though unlikely I would say. Depanelization method (bending a scored board to break it is tough on things). Bad PCB design - cap. too clo
Electronics Forum | Tue Jul 13 05:21:04 EDT 2010 | bubbobbed
Guys, I've received complaints from customer that the chip is sticking on the cover tape or carrier tape when detape. Is there any possible that i can solve the problem by changing the cover tape or carrier tape?? some say the root cause of this issu
.gif)
