Electronics Forum | Sun Mar 18 23:01:11 EDT 2007 | diesel_1t
Hi there, I want help on the following issue. Where I work, we place a component QFP 256 terminals (20 mil pitch)from hitachi (renesas), we use a MPM UP-3000 screen printer, IP-III placement machine and Vitronics 8 zones reflow Oven. lead plating
Electronics Forum | Thu Jun 19 21:39:31 EDT 2008 | mika
Hi, we used to have a RoHS package with uBGA 380 Solder ball's 0.8 mm pitch approx 15x15 mm, bump size is 0.4mm on a 0.33mm pad. Suddenly we need to use another vendor for various reasons. However, the new bump size is 0.45mm according to specs and t
Electronics Forum | Wed May 26 05:05:04 EDT 2004 | curious
hi, we have a batch-rework for a axial 2-lead LED component. we are thinking of bending both ends of the axial-leads into a L-shape at 90degree angle, and solder the flat-end of the L-shape flatly to the PCB's SMT pad. hope the experienced guys/exp
Electronics Forum | Thu May 27 23:16:49 EDT 2004 | curious
thank you for the advice.
Electronics Forum | Wed May 26 06:54:07 EDT 2004 | davef
Q1) if this is an acceptable component-lead modification? A1) Yes, it's acceptable Q2) and does this mod meet any existing IPC specs?(did a internet search but no result) Q2) IPC repair guidelines are: 7711A/7721A - Rework and Repair Guide For ot
Electronics Forum | Wed Dec 09 10:45:56 EST 2015 | huske
I've put down a SOT223, close enough to your 3pin transistor, in the same situation you have. The large pin was to be soldered on a large exposed ground plane in the corner of a board, over 2"x2" exposed area. We left the paste file as is, so where
Electronics Forum | Thu Apr 14 13:49:34 EDT 2022 | winston_one
Thank you for reply, Stephen. No, As I wrote it was leaded process. I heard that it is possible with lead free solder at higher temps an dwell time. At NPL Defect Database I've find this case wich looks exactly the same: http://defectsdatabase.npl.co
Electronics Forum | Thu May 05 12:31:27 EDT 2005 | russ
Not in this case, these BGAs were lead free and the profile used was for a lead part. I guess I will give you the whole story. These boards were sent to us from a customer to have the BGAs replaced for an unknown to us reason. We removed the parts
Electronics Forum | Wed Apr 13 12:10:47 EDT 2022 | winston_one
Hello! We have a strange effect. Some pads of big trough-hole DDR slot just dessapear. Initialy it was soldered with selective soldering process (leaded, 290 degrees, ImSn finish, very short storage). Then some connectors with poor barrel fill we hav
Electronics Forum | Thu May 06 19:21:24 EDT 2021 | markhoch
Verify your aperture reductions in the stencil. Are the solderballs always in the same location? Same size & shape? Is the solder leaching through plated thermal holes from the opposite side of the PCB? Are you using stencil apertures designed to min