Electronics Forum | Tue Apr 05 12:03:39 EDT 2022 | my3sons
Hello, we can offer you a great solution for handling these LED's which I'm betting are sticking to the nozzle after placement correct? We use a special tip material that doesn't stick...our part # 2014-2146 $450.00
Electronics Forum | Thu Apr 07 11:24:21 EDT 2022 | rasch
It's work on juki rs-1 ? this is dedicate nozzle or is the reworked standard nozzle ?
Electronics Forum | Fri Apr 01 08:42:03 EDT 2022 | rasch
Hi what Juki nozzle you use for xqeapa-00-0000-000000801 led?
Electronics Forum | Sat Apr 02 09:35:59 EDT 2022 | sophyluo1985
Hi,Rasch,I'm Quinn from GOLDLAND China.What do you need JUKI Noozle, we are JUKI experts. please send me your email。sales07@goldlandsmt.com
Electronics Forum | Tue Aug 01 09:27:13 EDT 2017 | tmennink
Hi all, We are having a lot of trouble with mis-pick trying to place silicone dome LEDs(3535 package) It seems that the silicone of the LEDs is sticking to the side wall of the carrier tape pocket. The vacuum nozzle would normally suck up the led an
Electronics Forum | Tue Aug 01 11:23:56 EDT 2017 | OrHorti
We are using a custom made nozzle, designed for this particular LED. The dome of the LED is also custom made, the diameter of the lens at the base is 2.9mm while the substrate of the package is 3.3mm, so this gives about 0.2mm spacing between lens a
Electronics Forum | Tue Aug 01 16:29:01 EDT 2017 | tey422
Try the method I mentioned earlier, it greatly improves most of the picked-but-drops issues. We never need to use any custom make nozzles, even for the trapezoid dome shaped LED we were having the issue with. Use smaller round diameter nozzle would
Electronics Forum | Tue Aug 01 09:45:58 EDT 2017 | dontfeedphils
Are you using a custom nozzle meant for the domed LEDs? If not, that should help quite a bit and are less expensive than you may think.
Electronics Forum | Tue Aug 01 11:09:44 EDT 2017 | mmjm_1099
Can you supply the following information to help with your question. 1. MFG P/N 2. Pick and Place machine being used 3. Type of nozzle and feeder being used on machine. We place a wide variety of LEDs and had similar issues and have to use custom
Electronics Forum | Wed Sep 06 14:41:02 EDT 2017 | tombstonesmt
You need to slow down the machine for starters. Try rotating your nozzle so that the touches the least amount of silicone membrane as possible.
