Electronics Forum | Mon Sep 29 13:36:01 EDT 2014 | dustin
I came into work this morning to an error on one of my printers. After powering on machine, the error MACHINE DOWN popped up in the top left corner of the screen. I have the giant manual and could not locate a solution for this error. I have checked
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Fri Sep 17 17:00:39 EDT 2010 | AL
we are using convection ovens and we face the issue when changing from Pb to RoHS but also even when change top side to bottom side if the diference on the profiles needs to go from a high temp to low, we are opening the hood but we would like not to
Electronics Forum | Wed May 11 11:21:11 EDT 2005 | russ
Been getting wacked by lightning for twenty years in this business. (three times yesterday as a matter of fact) We have never shut down in anticipation that we are going to get hit. I have lost one motherboard in all of these years that cost about $
Electronics Forum | Tue Jun 10 12:53:56 EDT 2014 | demzvill
Yes it will electrically but on the appearance side it is no good. Does it have something to do with the feeder or the nozzle?
Electronics Forum | Tue Jun 10 11:51:15 EDT 2014 | rway
Your target ppm in on the Juki machine a take it. So it's rejecting these parts due to the inversion? Any way to disable this. A right-side down resistor is not ideal, but it will certainly work electrically. Reese
Electronics Forum | Sat Aug 13 10:56:57 EDT 2011 | jldowsey
Process Flow #4 in davef's response is your best bet for this assemblly judging buy your pictures. We purchase our selective wave solder pallets from Ascentec Engineering - they can fabricate a pallet to hold your assemblies, keep the SMT devices pro
Electronics Forum | Wed Jul 27 22:43:10 EDT 2005 | crishan
Hi all, Having a major problem with an IC being placed upside down. We pick up the fault at AOI. We have check several reels and the component is not placed upside down by the supplier. Where should I start looking; 1. Are we using an incorrect fee
Electronics Forum | Thu Jul 28 03:49:06 EDT 2005 | aj
Are you seeing many of the components in the reject bin of the machine? If it is feeder related I would expect to see some rejects unless the part is jumping and landing in the same orientation i.e. 3 leads on same side everytime! Other than that I
Electronics Forum | Mon Aug 01 17:54:02 EDT 2005 | Stefan
If you are using vib. feeders than the component may be flipped length wise by the following components. Components should be landing with the leads on the right side but upside down. If you are using tape feeders the component may be flipped sideway
winsouce.jpg)
