Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Fri Mar 16 17:50:45 EST 2001 | djarvis
Steve, I did this several years ago on a terribly designed board that left a lot of joints unsoldered after the wave. It works OK. This was a bog Irish board with nothing fancier than SOP packages. Glue was Amicon D125. Happy St. Patrick's Day everyo
Electronics Forum | Thu Mar 15 16:58:11 EST 2001 | mparker
The only way I know of waving the bottom side with SMT parts installed without epoxy would be to use a masking media, Kapton Tape, wave pallet that keeps those parts from being susceptible to gravity once the connections are reflowed. If there is ano
Electronics Forum | Mon Mar 26 07:38:26 EDT 2007 | davef
The temperature that will melt solder holding top side SMT components during wave soldering depends on the alloy of that solder. So, for example, you'd expect: * Near eutectic SnPb solder to melt around 215*C. * LF to melt around 240*C. It's common
Electronics Forum | Wed Mar 24 16:54:38 EDT 2010 | stepheniii
J-STD-033B.1 Says "For cavity packages in which water may be entrpped, water clean processes after first reflow can be an additional source of moisture. This may present an additional risk, which should be evaluated." And it talks about derating if
Electronics Forum | Sat Jul 23 09:19:17 EDT 2016 | dalpets
I want to place smd's by hand from tape strips using a vacuum pump. What is the orientation of polarised smd components on reels/tapes? Is there a standard manufacturing orientation, or are there variations? I understand some manufactures have part
Electronics Forum | Thu Feb 27 15:14:53 EST 2020 | SMTA-Alex
This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an A
Electronics Forum | Sun Jul 23 18:04:51 EDT 2006 | mika
4. There is a possibility that your company have more than one vendor for a specific component (same partnumber for you but different mfg. part nr). Let say that it is a red led and this itself could be somewhat tricky to order: Red led is as most of
Electronics Forum | Thu Jan 15 12:55:03 EST 2004 | James
Polarity in tape and reel is usually always on the bottom left side. And that is correct for the trays, they have a corner taken out where the polarity goes. Hope that helps........
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
winsouce.jpg)