Electronics Forum | Wed Sep 04 10:10:10 EDT 2019 | jameshoward
I know exactly what your problem is as I have seen it many times. Your problem is with indexer 1 (the cylinder which runs up and down and actuates feeders on side 1). At each end of the travel of the indexer is a micro switch hidden down below the be
Electronics Forum | Tue May 21 08:26:14 EDT 2002 | stefwitt
without knowing your machine, I guess the axis does not find the zero pulse. You may have to re-place the incremental or linear encoder for the X-axis. Some vendors use proximity switches for a zero pulse which could be defective. If the axis stops i
Electronics Forum | Thu Sep 15 10:43:18 EDT 2016 | claudea2
Thanks to Bobpan we re connected our wipe system and all the air actuators work fine. I still have a problem with the cleaner fluid dispenser. It is not moving as it should to dispense the liquid when we do the command. I suspect the values in the c
Electronics Forum | Fri Feb 13 09:25:35 EST 2004 | jcdupree
Hi Patrick, I can easily troubleshoot ML, EL and SL 20 systems by phone or e-mail, but the MPC-29 is a bit more complex. The problem that you are describing was failry common, and there were a number of potential causes. First is to check if the dr
Electronics Forum | Fri Sep 24 10:43:42 EDT 1999 | Ken Kkoyen
| The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table mo
Electronics Forum | Fri Sep 24 13:44:06 EDT 1999 | Eric Lee Williams
| | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table
Electronics Forum | Mon Oct 15 14:29:58 EDT 2018 | compit
I have an Emerald X machine (by Assembleon) with an LCS. I start production. The first PCB board runs to the end of the LCS (item 1). Each subsequent stop is BEFORE LCS (item 2) - I have to remove it manually. And so until the production reset - then
Electronics Forum | Fri Sep 24 20:33:44 EDT 1999 | Ron Gillam
| | | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y tabl
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Mon Feb 08 23:16:07 EST 2021 | mendez
Hi, so I was able to turn the machine on for a few seconds. It looks like the IC on the LCD doesn't have goo contact because it's very hard to keep the machine operational. I was able to see the table lifting for the first time; it was so cool! but t
