Electronics Forum | Thu May 07 20:28:35 EDT 2009 | davef
From our notes, the following is a series of snips from: "Copper Dissolution in Tin" LJ Turbini, PhD, adjunct faculty member, University of Toronto, Materials Science and Engineering, SMT 2/07 As the solder becomes molten, copper from the board diff
Electronics Forum | Fri May 01 08:15:36 EDT 2009 | davef
Scavenging Methods [Improve Solder Scavenging of Large Area-array Sites, SMT, Laurence Harvilchuck, process research engineer, Unovis Solutions, harvilch@unovis-solutions.com] Two common methods exist for scavenging residual solder on the site for s
Electronics Forum | Wed Oct 03 23:59:44 EDT 2018 | gaintstar
Flason SMT problem solving: http://www.flason-smt.com/new/PRINCIPLE-OF-SURFACE-MOUNT-PROCESS-SMT-PROCESS.html http://www.flason-smt.com/new/Printed-Circuit-Board-PCB-Price-Estimator.html http://www.flason-smt.com/new/Printed-Circuit-Board-Solder-res
Electronics Forum | Mon Aug 17 02:50:44 EDT 1998 | Bob Willis
| Have an SRT w/preheat, 18 layer board all copper, 456 BGA needs to be removed and replaced. The manufacturer is Chip Express and during reflow it warps up or down. Causing either opens or shorts on the corners. I was using gel flux with multiple
| 1 |
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
