Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
Electronics Forum | Thu Sep 16 08:47:39 EDT 2010 | headlad
I extended the pads to help ensure the component locates correctly and to allow for easier re-work should problems occur. I reduced the thermal by 5% but you may want to speak to your fabricator and ask what they require to ensure that the resist is
Electronics Forum | Tue Jul 27 16:08:04 EDT 1999 | Kathleen at ATL
I'm working on a prototype board that requires a 600 pin BGA. This is a metal top BGA being placed on a 11" x 17" PCB about .62" thick. The part is 1.77" square with a 50 mil pitch and 30 mil bump diameter. The bumps are located on the perime
Electronics Forum | Tue Aug 11 08:19:48 EDT 2009 | cyber_wolf
Has anyone located an alternate source for the Fuchs Stabylan oil that Vitronics calls for ? $65 a pint seems a little stiff.
Electronics Forum | Thu Jul 29 11:14:46 EDT 1999 | Justin Medernach
| I'm working on a prototype board that requires a 600 pin BGA. This is a metal top BGA being placed on a 11" x 17" PCB about .62" thick. | | The part is 1.77" square with a 50 mil pitch and 30 mil bump diameter. The bumps are located on the
Electronics Forum | Tue Jul 27 16:22:17 EDT 1999 | Earl Moon
| I'm working on a prototype board that requires a 600 pin BGA. This is a metal top BGA being placed on a 11" x 17" PCB about .62" thick. | | The part is 1.77" square with a 50 mil pitch and 30 mil bump diameter. The bumps are located on the
Electronics Forum | Thu Jun 07 18:09:21 EDT 2007 | stephan
We noticed unsufficient soldering on some 0805 chips located between pins from a plastic bloc connector . All chips are soldered with 45� angle. Flux quantity , preheating , contact time and PCB quality was checked. Do you know any international stan
Electronics Forum | Thu Apr 29 17:52:33 EDT 2021 | mike_infl
We have an assembly which we are trying to machine pick and place a Mil-Max pin that is .020 dia placed in a .026 hole. The board is .1125 thick. We have to place 106 of these pins. Without going into the challenge of getting proper hole-fill to me
Electronics Forum | Wed Mar 21 20:40:28 EST 2001 | dblsixes
We are building a monster ... Dimensions are 10" x 7" ... 12 layers ... A Logic Assembly with a Power Supply all rolled into one ... The Power Supply is in one section of the board, the logic in the other section ... The Power Supply obviously has a
Electronics Forum | Wed Jan 15 11:18:51 EST 2020 | avillaro2020
Hi Evtimov, Thanks again! The solder wicking/open solder joint is not actually gross rejection, it is only a few and appeared random (difficult to trend the location of the opens), what is perflexing is that i have this 1 or 2 open solder joints sur
.gif)
winsouce.jpg)
