Electronics Forum | Wed Feb 26 13:21:30 EST 2003 | gregp
Are the markings on resistors the actual value? Do AOI machines look for these markings or do they just look to see if a component is present and placed well? Can anyone attest to the solderability of upside down resistors? Can anyone argue that u
Electronics Forum | Tue Feb 04 08:20:18 EST 2003 | roertner
This rule is very conservative depending on the epoxy you use and the subsequent handling of the board prior to reflow. You should use lead to pad contact area. Also be sure to look at part height and clearance on your flowsolder machine.
Electronics Forum | Wed Feb 05 11:26:57 EST 2003 | pjc
Arguably the finest axial lead cut and form machine ever created. They go for like $25K new. Can do almost any type of form. Good German engineering!
Electronics Forum | Sun Feb 09 23:41:37 EST 2003 | Dreamer
What are the key features that I need to know when evaluating an X-Ray Inspection Machine? Thanks for your feedback
Electronics Forum | Thu Feb 13 11:00:07 EST 2003 | cbarnett
Looking for feedback from anyone that is currently screen printing adhesive and having good results. If results are good, what type adhesive and type machine is being used?
Electronics Forum | Sun Feb 23 15:28:35 EST 2003 | davef
"Blank" means "bare board". Gray beards used this expression a lot. It has stuck in many companies, even after the old timers went to work on the BIG wave solder machine in the sky.
Electronics Forum | Fri Feb 21 16:03:00 EST 2003 | pjc
Is anyone out there dispensing no-lead paste with a machine? If so, please give me some feedback- do you see any difference in performance vs. lead content paste? What type of valve/pump are you using. Thx in advance.
Electronics Forum | Fri Feb 21 17:24:50 EST 2003 | Robert Culpepepr
Does anyone have any experience with CAM software used on Assembleon (Philips) Gem equipment? I'm looking for something that doe's it all, Imports CAD, Provides Documentation, Line Balance, Placement Optimization and (LAN) Machine Communications. An
Electronics Forum | Sat Feb 22 12:21:33 EST 2003 | jersbo
I currently use circuitCam and it works well for ("Imports CAD, Provides Documentation, Line Balance, Placement Optimization") I dont use it for ("(LAN) Machine Communications") Philips(assembleon) has whats called PPS which you also may want to chec
Electronics Forum | Mon Mar 10 16:16:29 EST 2003 | Tim Chistianson
Good note about in Line washers. Can you tell me a little more about the Wave machines, may be what models did you worked on, and what you liked or did not like about them. Thanks, Tim
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477