Electronics Forum | Wed Jan 29 13:01:04 EST 2014 | tech1
Back when the Linear Y wagons first came out Mydata had problem with the original Y amplifier and were swapping out the complete box for customers who had problems. There was also a problem with the encoder that resulted in the same type of errors yo
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Wed Jan 29 18:41:22 EST 2014 | alphatronique
Hi did you look for mechanical issue like friction somewhere ? when init i use very low force buy much more while running that may explain wly machine work in production fur fail only on init i face that whit flex cable that make just little fr
Electronics Forum | Fri Jan 10 03:33:42 EST 2014 | hans88
hello people, we have a my12 wich has a problem it gives the following error during hardware initialization: F-MOT-MSETDYN Y/1236 :Motor amplifier channel a error. after this error it says hardware initialization failed. this prevents us of using
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
Electronics Forum | Mon Feb 12 17:16:04 EST 2024 | bobpan
The width motor gets power from an amplifier SPA2100S. I would check the amplifier. It also has the encoder plug into MT1 card at enc3 input.
Electronics Forum | Tue Mar 28 19:43:49 EDT 2017 | aemery
Simon, Trying to dust off my 400 knowledge here, I can picture the 500 and 1500 better in my head. I think the 400 also has a Z axis amplifier box in the back of the machine. Remove the rear lower door and pull out the big square vacuum box. If it
Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan
Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P
winsouce.jpg)