Electronics Forum | Fri Jan 08 21:46:49 EST 1999 | Dean
| | This is a question for those of you who actually assemble components onto a board. | | Any idea what the "industry standard" is for fall out on assembled PCB's? I realize that the controls put in place in your processes will effect your overall
Electronics Forum | Mon Jan 11 18:07:55 EST 1999 | Lech Bartnik
| | | This is a question for those of you who actually assemble components onto a board. | | | Any idea what the "industry standard" is for fall out on assembled PCB's? I realize that the controls put in place in your processes will effect your ove
Electronics Forum | Mon Dec 23 07:33:04 EST 2013 | aflex
It totally depends upon the configuration of both bare PCBs and assemble PCBs.
Electronics Forum | Mon Dec 23 00:22:58 EST 2013 | basheermd
One of our production plant is currently using your SEica Flying Probe Tester whose model and serial no. is furnished below. Model S22 MT Serial No. 200594. Now, they want to use it for both bare pcb and assemled pcb testing. Please furnish th
Electronics Forum | Wed Dec 25 02:17:01 EST 2013 | alexeis
Hi, Flying Probe uses only for symptom detection. Do you have software tools for repair station that can helps to your engineering to detect cause? If you need a software tools, feel free to contact me by email: alexeis@proventustech.com. Best Reg
Electronics Forum | Tue Mar 18 11:53:58 EDT 2014 | sara_pcb
Our contract manufacturing agency have procured pcbs from approved vendor. After assembly we found solder mask separated from the PCB on the epoxy area as patches. The top side is intact. also over the pcb tracks, the mask got damaged. In what c
Electronics Forum | Fri Jan 08 13:22:11 EST 1999 | Earl Moon
| This is a question for those of you who actually assemble components onto a board. | Any idea what the "industry standard" is for fall out on assembled PCB's? I realize that the controls put in place in your processes will effect your overall qua
Electronics Forum | Fri Jan 08 10:11:15 EST 1999 | Tim
This is a question for those of you who actually assemble components onto a board. Any idea what the "industry standard" is for fall out on assembled PCB's? I realize that the controls put in place in your processes will effect your overall quality
Electronics Forum | Mon Jun 05 14:09:36 EDT 2000 | Jason
We would like to gauge or precentage of production line failures to industry standard AQL level. What would be an acceptale AQL level for assembled pcb's or finished units leaving the factory?
Electronics Forum | Mon Jul 31 01:24:28 EDT 2006 | fastek
If you ask me, these were the two issues that contributed the most to the decline in PCB Assembly Manufacturing in the US...for that matter the electronics industry in general. 1) The obsession of management to please shareholders which was driven f
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830