Electronics Forum | Wed Aug 17 10:46:48 EDT 2005 | pjc
MPM did not discontinue the camera, the camera manufacturer did. It�s not a custom made camera for MPM. Try searching used or second-source cameras. There are three types of vision systems offered on the SPM: manual cross-hair, semi-auto and high-res
Electronics Forum | Wed Aug 24 12:25:52 EDT 2005 | bman
We've been down this road before, and it doesn't have to be as expensive as it would seem. First, ask your board supplier for a solder sample of the board. They are likely to have a scrap board that you can use for your profiling. As for the BGA(s
Electronics Forum | Thu Aug 25 10:07:02 EDT 2005 | Rob
From reading back through the post, it looks like you still need to establish whether the parts are actually being damaged, or just not soldered properly. If you're worried about heat damage get the manufacturers recommended reflow profile and che
Electronics Forum | Thu Aug 25 16:50:13 EDT 2005 | Mark
I have an application that requires soldering pieces of metal (copper plate and copper fins to make a heatsink). Each piece is about 1 lb. I cannot test it in our reflow oven (5 zone) since the piece is about 3" in height. Has anyone attempted to
Electronics Forum | Thu Sep 01 14:24:44 EDT 2005 | lsmith
I do not have a ERSA Versaflow but do have some ERSA equipment. Only can tell you I will most likely not purchase anything else from them. The experience I have with their service after the sale would have to be rated VERY low. In addition, they emai
Electronics Forum | Wed Aug 31 11:02:28 EDT 2005 | Jason Fullerton
We are using one BGA that has 7 mil bumps on a 20 mil pitch. We use the manufacturer's recommended pad and aperature layout, which is an 11.8 mil square overprint on a 6 mil land. At 11.8 square, you need to use a 4 mil laser cut or a 5 mil e-form st
Electronics Forum | Wed Sep 07 04:40:50 EDT 2005 | Slaine
i worked for a mobile phone base station manufacturer a few years back and they had a customer in Thiland who were complaing the cabinets we sent them were dented and marked, we investigated, improved packing and goods out inspection but still had th
Electronics Forum | Fri Sep 09 15:53:22 EDT 2005 | patrickbruneel
If the white residue is from a no-clean flux or no- clean solder flux core you can leave it on the board. (Consult with the flux or cored solder manufacturer) Because after being encapsulated with conformal coating the residue is sealed from humidity
Electronics Forum | Wed Sep 21 16:23:36 EDT 2005 | 14367
I was going to ask the same question. As was mentioned, it depends on the classification of product. If it's IPC Class 3, with a requirement for high reliability, I'd want the OEM manufacturer to have a defined statement on this issue for more that
Electronics Forum | Fri Jun 23 12:17:11 EDT 2006 | kevindebarra
Dear Greg and PWH, I see from your comments above, that you are still unsure whether splicing is for you, and mention that you have yet to find a "good splice tool." QTEK Manufacturing Ltd. based in Ireland, Mexico and Hungary provide a unique tool
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
.jpg)
