Electronics Forum | Mon Aug 07 17:03:45 EDT 2006 | Harry
What is the name of the dross eliminator you are referring to? Who is the manufacturer? I went to your website and didn't see anything about it? I just ordered some MS2 from P. Kay Metal as I've been hearing some very good things about it from longti
Electronics Forum | Mon Aug 14 12:08:35 EDT 2006 | cuculi54986@yahoo.com
I agree with using the homeplate design on chips. Some Pb-free solder paste manufacturers recommend 1:1 apertures. This, in my experience, is not a good idea with any of the SAC305 pastes I've tried. I've been using the same stencil design guideli
Electronics Forum | Thu Aug 17 10:30:08 EDT 2006 | Chunks
Hi McGill, The straight ramp is "straight" from the manufacturers of the material. Using old process techniques from your old process materials no longer applies. We all miss the good old days, but it�s time to move on. Being of Asian descent, I t
Electronics Forum | Fri Aug 18 11:26:08 EDT 2006 | Board House
Hi Mark, Couterbore is possible in two way's during PCB Manufacturing. Couterbore plated and non-plated. Meaning that the entire hole will either have to be Plated or Non-Plated. Prefered Methode is Plated, to accomplish this your PCB house would
Electronics Forum | Wed Sep 06 17:13:17 EDT 2006 | Board House
PB-free Hasl was not mentioned due to the following: 1)Equipment Convertion at the PCB Manufacturing side is expensive. 2)You are subjecting the PCB to Higher Temps than Std. solder. 3)Most PCB Houses are not going to invest in Two Hot Air level
Electronics Forum | Wed Aug 30 08:59:40 EDT 2006 | saaitk
Our facility in Asia wants to change their solder paste to a local manufacturer. I have recieved specs for this paste and compared to our existing paste spec, there is not really much difference in material composition. The Asia spec tests the paste
Electronics Forum | Thu Sep 07 10:52:21 EDT 2006 | Machine Designer
Tsk tsk, UIC... how the mighty have fallen... now owned by financial partners who do not know the industry and who will be eager to recoup an investment in an aging manufacturing industry which sorely needs new and strong global management... Not men
Electronics Forum | Wed Sep 13 08:08:56 EDT 2006 | meritajs
Hi Davef and Rob, Thank Davef for your advice,we will make "dip&look" soldering test. Rob,we are tolking about companents storage time after manufacturing. Sometime we get companents which was shipment more then year ago In many cases we have problem
Electronics Forum | Fri Sep 15 11:38:19 EDT 2006 | scott
I want to thank you for your help. MPM SN's are continuous (7001 to the more current 7780's), no date included. I had already contacted MPM and their Technical Support personnel could/would not pin-point the year it was manufactured, hence the reas
Electronics Forum | Thu Sep 14 10:22:06 EDT 2006 | Al Czervik
Are you a big CM ($1 billion)? If so, your company probably has a legal department. I would consult with the company's legal department on this. I'd be very, very nervous with nothing in writing (a waiver that they are aware that their product i
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
