Electronics Forum | Sun Jan 28 03:36:53 EST 2007 | sami
hi to all. I am new in this forums. but I like it too much. i am working on universal machine but sometimes i had a problem when the CAD data ( X,Y,Theta ) information are not correct, I adjust them manually in Board Enhanced Setup, my question is th
Electronics Forum | Mon Jan 29 03:33:33 EST 2007 | sami
thanks I haven't the same shift in all the components, that's why I need to correct them one by one and this takes a lot of time. I am searching in the Software of the machine if there is any way to change just one parameter to correct all the data
Electronics Forum | Mon Feb 05 16:00:32 EST 2007 | vickt
Sami, Have you contacted Universal directly for assistance? You can contact your local service team, or contact them at GSMTechs@uic.com. There is also a set of online "Knowledge bases" that are at your access 24/7 if you are a UIC registered user.
Electronics Forum | Sun Jan 28 22:54:58 EST 2007 | darby
Welcome Sami. I am unfamiliar with Universal but in general.... If all of your placement is out the same amount in the same direction then your fiducial data is probably incorrect. This can also be caused by a machine offset problems. If all or som
Electronics Forum | Mon Jan 29 10:52:57 EST 2007 | jaimebc
You are probably using a GSM since you mentioned "enhanced board setup". 1.- Your CAD data. It works better when all your data uses bottom left of the PCB as a board origin ( BO ). If my CAD does not use bottom left as a BO, then I edit the data in
Electronics Forum | Thu Feb 01 07:06:46 EST 2007 | Sami
thanks to all . I am using GSM Genesis machines. I am also using using a single board without any offset. When I tried to test the first board for a new product, I can see the shiffting in the placement of some components. Yes I know that the default
Electronics Forum | Thu Feb 01 16:33:57 EST 2007 | mika
The reject rate of yours could be a number of reasons. 1. Which component types are rejected? 2. From a particular nozzle? 3. If the rejected part will be dropped on the reject belt or reject bin; it suggests that there is a problem with the componen
Electronics Forum | Mon Jan 29 08:18:48 EST 2007 | mika
Hi Sami, A little more detailed information would be good,as it perhaps makes it easier for us to point you in the right direction of the root cause of your problem. And then you should fix that, rather than tweaking your programs around. 1. What typ
Electronics Forum | Mon Jun 18 08:25:59 EDT 2001 | Carl Evans
The install of the new closed loop system is totally dependant on which m/c and levell of software you have. the maximum time it should take for a older m/c that has to have new wiring run in the m/c should take no longer than five days including tra
Electronics Forum | Mon Dec 06 21:38:22 EST 2021 | erici
Thanks victor, will go with your suggestions. By the way, would you happen to have some info on how to work the MC distributor? When i was working on the hard drive of the machine i was able to re install the MC software on a fresh harddrive, as i u
