Electronics Forum | Sat Apr 25 19:40:01 EDT 1998 | Stan Traxler
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components We have appl
Electronics Forum | Tue Aug 04 03:54:04 EDT 2009 | rafacadiz
I would like to perform a Solder paste height capability study. I will apreciate any info about and what equipment use to measure the height of the solder paste. I only found the attached equipment. Solder Paste Height Measurement System (SPM-300-3D
Electronics Forum | Tue Jul 13 14:48:49 EDT 2004 | Mark
I was wondering some input on what to use for measuring height on our solder paste for SMT placement. Is there a place to buy a machine or a scale in which you can use? I know in the past I have used a laser scope at another facility but where I am n
Electronics Forum | Tue Feb 22 07:58:16 EST 2005 | davef
We hear you. If it's not broken, why fix it? Right? Well intentioned, but not very educated customers seems to be part of the bane of existance of process engineers at contractors. First, as a previous poster said, paste height is an improper mea
Electronics Forum | Mon Feb 21 04:04:21 EST 2005 | abhirami
1.67 always on the sample boards measured. This is very fast and pretty good measurement for a paste dispense control. Boards do not stand out-side for long times. Inspect the height for critical components only, in the initial stages. Once your Cpk
Electronics Forum | Thu Mar 05 13:03:07 EST 2009 | smtnet51
Are you using HASL PCB's? Try measuring a bare board and compare.
Electronics Forum | Thu Mar 05 09:54:59 EST 2009 | davef
When you measure "solder paste heigth of 7 & 8 mils using a 5.0 mils stencil," are you measuring the top of a flat brick? Sometimes if you snap-off the stencil too fast, the paste touching the stencil walls form peaks along the edge of the brick that
Electronics Forum | Tue Jul 13 16:19:05 EDT 2004 | Inspection Solution
Hi Mark, There are many tools available for measuring solder paste height. Most machines use laser as the basis for inspection while others use structured white light. If simple height and width inspection is all that is required, you can look int
Electronics Forum | Tue Feb 21 21:17:41 EST 2006 | Cal Kolokoy
M, The paste height is what you establish it as. You're probably using a laser measurement system, and these depend on where your reference datum is. Some will measure from a silkscreen, a trace, or solder mask. These add height, not to mention H
Electronics Forum | Sat Aug 07 04:11:57 EDT 2004 | AOI Solution
This is Ivan from TRI USA located in Santa Clara, CA Our company provide a Solder Paste Inspection System which uses 635 Line Laser to scan the panel and come out a real 3D height, area and volume measurement! We sold lots of this system in Asian EMS