Electronics Forum | Mon Aug 27 11:20:58 EDT 2007 | davef
Q1: Is it sufficent to simply put meter probes in the water to get a resistance reading? A1: No. You need a meter for the purpose. Myron-L [myronl.com] is one such company Q2: I'm very skeptical of the Culligan man as they tried to pass distilled w
Electronics Forum | Wed Feb 23 07:53:48 EST 2000 | John
Anyone out there have any experience with paste dispensing equipment? With our high mix of baords and very low volume (
Electronics Forum | Wed Feb 23 07:53:48 EST 2000 | John
Anyone out there have any experience with paste dispensing equipment? With our high mix of baords and very low volume (
Electronics Forum | Sat Aug 25 12:22:30 EDT 2007 | erokc
Is it sufficent to simply put meter probes in the water to get a resistance reading? I'm very skeptical of the Culligan man as they tried to pass distilled water for DI water. As I watched my container being filled I asked how they determined when
Electronics Forum | Mon Sep 22 12:21:10 EDT 2003 | dougt
You can use a meter in "diode mode" to illuminate an LED to check a batch. Hopefully your stock room doesn't open the container and poor them all into a bucket to be issued out to the floor.
Electronics Forum | Fri Jun 14 14:32:05 EDT 2002 | davef
There is no real reason why you shouldn�t use your current paste. Paste for printing usually is a coarser mesh than paste for dispensing. Dispensing paste is more expensive, because of the mesh and the packaging, but that doesn�t matter now. Compa
Electronics Forum | Tue Jun 15 19:14:51 EDT 2010 | hegemon
You also need to consider the total metal load in your dispensable paste. You'll need a slightly higher flux content and less metal, say around 87% total metal, in a 4 or 5 mesh size. We had to have some special mixes made in order to do fine pitch
Electronics Forum | Fri Aug 08 18:06:35 EDT 2003 | davef
Antistat sprays are a waste of time and money. These sprays just soaps disolved in water that absorb moisture from the air. Your minimum requirements: Conductive floor mats and wrist straps that are properly grounded. From there, consider using
Electronics Forum | Wed Feb 23 11:02:41 EST 2000 | John
John, I'll try to take a crack at it. We manufacture our own boards, and have a high mix. We currently have BOTH a Camalot 2800 Dispenser and a DEK 260 Screen printer. We use the camalot for glue applications, and prototype paste. We use the printe
Electronics Forum | Wed Feb 23 11:02:41 EST 2000 | John
John, I'll try to take a crack at it. We manufacture our own boards, and have a high mix. We currently have BOTH a Camalot 2800 Dispenser and a DEK 260 Screen printer. We use the camalot for glue applications, and prototype paste. We use the printe
.gif)
winsouce.jpg)