Electronics Forum | Thu Mar 24 17:37:35 EST 2005 | SuePH
Am looking for a table top mini wave to remove connectors or solder in connectors in hard to reach areas. Can anyone recommend a good brand. Thanks
Electronics Forum | Wed Apr 13 15:03:05 EDT 2005 | haviland
Am looking for a table top mini wave to remove > connectors or solder in connectors in hard to > reach areas. Can anyone recommend a good brand. > Thanks Hi--We have a couple of Wenesco Rework units, (1) for SMT and the second for PTH. These ar
Electronics Forum | Fri Apr 29 17:42:50 EDT 2022 | jdengler
It's either a 6 pin DIN of 6 pin Mini DIN. The diameters are different so check that.
Electronics Forum | Mon May 14 12:44:08 EDT 2012 | tomgervascio
I am a user of an Ersa Versaflow 3/45. I was wondering if anyone could share some process pointers. I have a 0.125" multilayer PCB that I am having problems consistently achieving 75 percent hole fill on a mini-coax connector. The coax connector ha
Electronics Forum | Thu Jan 14 22:52:28 EST 1999 | Wayne
I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some const
Electronics Forum | Fri Sep 10 15:15:09 EDT 2021 | majdi4
Hello to all , Could you help with this defect .. Tombstoning 0201 , always at the same place in board , only this component near to the coax connector..with a defect rate of 2 % ..All the process is perfect . i cheked : stencil design , SPI resul
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
Electronics Forum | Fri Apr 05 13:42:05 EST 2002 | dougt
We have been using a silicone encapsulated, high flex, flat cable for a short time now and have not been succusfull in terminating it to connectors with shell housings designed for round cable. Our solution thus far has been to leave the housing off
Electronics Forum | Thu Jan 14 23:38:34 EST 1999 | Chris G.
| I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some con
Electronics Forum | Thu Jul 14 14:31:11 EDT 2005 | johnnie8
A customer has asked us to solder a surface mount mini USB connector to a board. They need the connector housing to center on an opening in a plastic panel. The question is how much does the solder process add to the overall height of the coonctor, e
