Electronics Forum | Mon Jan 04 11:03:14 EST 1999 | Chrys
| | | We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I rea
Electronics Forum | Thu Sep 02 10:35:46 EDT 1999 | Gian.D
We are assembling double side pcs reflowing (smt) on top and by wave on bottom. After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. After wave soldering we f
Electronics Forum | Thu Sep 02 14:42:52 EDT 1999 | JohnW
| We are assembling double side pcs reflowing (smt) on top and by wave on bottom. | After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. | After wave solderin
Electronics Forum | Tue Sep 07 12:51:02 EDT 1999 | Brad Kendall
| | We are assembling double side pcs reflowing (smt) on top and by wave on bottom. | | After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. | | After wave so
Electronics Forum | Wed Jul 29 12:58:35 EDT 2015 | pankyb1261
Is there anyone that makes a pick and place glue dot for surface mount chip components (B stage epoxy dot in a carrier tape)? Thanks, Rich
Electronics Forum | Wed Jul 14 14:46:19 EDT 1999 | Ron Goodmuth
Can plcc's be glue on the a board if not why?
Electronics Forum | Fri Dec 29 12:46:24 EST 2006 | realchunks
Crappy piles? Weren't they a hard rock band in the 80's? I know on most of our boards the little silk screen dot is just the component identifier in really small font when looked at in Gerber. But this dot isn't very big, so I see how it can affec
Electronics Forum | Thu Dec 28 09:49:18 EST 2006 | slthomas
Tough call without seeing the board, but here's my best guess. You don't say if the glue dot is greater in height or diameter in the locations where you have printing (silkscreen), but I would guess that you might get either, or both, depending on ne
Electronics Forum | Fri Oct 05 07:46:24 EDT 2001 | george
Specifications of testing force are not fixed, but (incase of wave soldering) the value should be at least 120-150 % of the force the wave. So for small chip components we assume that the force from the wave on the component is about 3 Newton, this m
Electronics Forum | Mon Sep 03 03:32:47 EDT 2001 | johnw
Franky, what method are you using for printing glue? metal stencil or plastic?, and is it on contact or off contact ? and what type of squeegee's are you using? basically give us more infomation. In term's of measuring height / volume, you can do t
.gif)
