Electronics Forum | Tue Aug 12 08:25:45 EDT 2008 | sumote
We have had a few circuit cards come off the end of the oven and get damaged. Most cards have no problem sliding onto a ramp, but a few don't fare so lucky. Has anyone had any luck using a motion detector with an audible alert? I tried google, but I
Electronics Forum | Wed Jun 08 13:16:02 EDT 2005 | cyber_wolf
It sounds to me like it may be your squeegee Z motion controller card. The SQUEEGEE Z motion controller card is interchangeable with some of the other motion cards in the back of the machine.(NOT ALL OF THEM) Make sure you look at the power ratings a
Electronics Forum | Wed Sep 01 00:41:13 EDT 2004 | valuems
Hello Since we carry a very large assortment of MPM spare parts I feel sure that we have them in stock. Call us at 740-344-4260 And this is not the place to be looking for replacement parts. Cancel your posting and I will do also. harry
Electronics Forum | Mon Jan 28 07:37:23 EST 2019 | babe7362000
You could also try swapping the motion cards. X and Y are swappable I believe. And see if the problem goes to the X. I have had to do that in the past for troubleshooting. It has been awhile since I have touched a IVC, but I loved those machines.
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Fri Feb 01 07:07:01 EST 2019 | dfl
Another semi-related question: are the four motion cards the same? (except for the dips, I guess). I have a spare one, marked as T motion, all dips to up position. Can I use as X or Y, if I match the dips? The boards look like to have the same comp
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
Electronics Forum | Thu Sep 23 11:37:43 EDT 2010 | flipit
I had 4 of these machines. They are good machines but I have seen this error often. Is the problem only on one head L or R? If so swap electronics L to R and see if it follows. You can even swap the Y motors. The items that could cause this prob
Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799
I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst