Electronics Forum | Wed Dec 14 11:35:32 EST 2011 | eezday
I have had this problem and I've resolved it. I don't have access to the PW at this moment but I've requested it be sent to me. Please don't give up on this thread. Try these passwords: "anders" and "akuankka"
Electronics Forum | Thu Oct 24 03:28:45 EDT 2019 | mfurlandea
Hello, i need an information about Fuji Aimex II and the problem when you have a multi offset pcb and you need to mount some offset with one program and the rest with a different program. So process dispense paste, mounting, changing program and moun
Electronics Forum | Fri Nov 14 17:37:58 EST 2008 | snsmt
WHat about bad mounting? i have 2 fixtures and sometimes it would mount with no misalignment and sometimes it would. WHat could be the problem in this case/ I know the fixtures are good because they work on a different program that we have. I don't u
Electronics Forum | Fri Aug 14 10:02:23 EDT 2015 | swiese242
Yes your CP8 should place these flawlessly. I would calibrate the machine and check your nozzles. We have some CP7's and they rock. We use a .4 nozzle for the 0201's with no problem. Always check your program, feeder, nozzles, and nozzle check before
Electronics Forum | Mon Nov 17 04:03:08 EST 2008 | griffin
If the whole board is shifted then it must be a problem with the clamping of the fixtrue to the machine or the board to the fixture, or the fiducial reading that is incorrect. Are the fixation of the board to the fixture the same in both programs? A
Electronics Forum | Sun Apr 19 13:52:45 EDT 1998 | D.Lange
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components Robert, PPI
Electronics Forum | Sun Apr 19 13:50:41 EDT 1998 | D.Lange
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components Robert, PPI
Electronics Forum | Tue Apr 28 14:50:43 EDT 1998 | Chrys
| | We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | | PCb substrate to compensate for thermal stressing in a | | Space enviroment. Has any one any ideas or contacts for | | dissolvable pads. this only applies to leadless components | Ro
Electronics Forum | Wed Nov 12 06:23:09 EST 2008 | griffin
One thing to consider regarding the capacitor, The leads are not 100% straight beneath the plastic bottom part. And if you align with regards to the two leads, the leads will be aligned to the pads of your board, but the body of the capacitor is look
Electronics Forum | Thu Jun 10 16:40:48 EDT 2021 | cyber_wolf
Yes those verifiers seem like a good idea but they really don't work correctly. You would be better off verifying with a meter during reel changes than wasting your life on that thing. I concur that single mount will show the value.
winsouce.jpg)